669705
11
Zoom out
Zoom in
Previous page
1/25
Next page
SYNCING CONTROLLER AND BOARD
9
3
5
1
2
4
Use the pin tool (page 8) to slide the speed
switch (positioned on the left side of the
controller) fully down.
Slide down the riding mode switch
(positioned on the left side of the wireless
controller) to 'ECO' mode.
Make sure the 'BLUETOOTH' switch (ill. 4) is
switched to the side closest to the motor,
then turn on the board by switching
the power switch on. The board should
now beep two times and its battery status
indicator should be flashing fast.
Begin with the 'BLUETOOTH' switch
flipped toward the right (closest to the
motor). Immediately after powering the
board ON, move the ‘BLUETOOTH’ switch
to the left (furthest away from the motor)
and back to the right (closest to the
motor). Then the battery status indicator
should go from flashing fast to flashing
more slowly.
Slide down the wireless controller’s throttle / brake to the lowest possible position, and
hold it there. At the same time, press and release the start button while the throttle/brake
is still held down. After 7 seconds, the controller will show 8 green flashes, followed by
blue flashes. At this point release the throttle / brake. The board should now beep again,
indicating a successful synchronization.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yuneec E-Go at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yuneec E-Go in the language / languages: English as an attachment in your email.

The manual is 0,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yuneec E-Go

Yuneec E-Go Quick start guide - English, German, French, Spanish - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info