663743
15
Zoom out
Zoom in
Previous page
1/86
Next page
24
23
The unit will not turn on.
Check that the batteries are correctly fitted in
the battery compartment.
Check battery operation.
Oxidized contacts in the battery compartment
due to “leaky” batteries or contacts have been
exposed to a chemically active liquid.
Replace the batteries or fit the batteries
correctly.
Check
Corrective action
Problem
Clean the battery compartment,
clean the contacts.
Poor image quality. Check that the eyepiece and lens are adjusted
in accordance with the user manual.
Adjust the unit according in
accordance with the user manual.
Adjust brightness by rotating the
controller.
The lowest brightness level is set.The image is too dark.
Make sure the lenses are not misted or soiled. Clean the lenses with a cloth
moistened with alcohol.
The unit does not
operate on external
power supply.
Make sure your power supply Is providing
output voltage.
Charge the external power supply
(if required).
Check that the USB cable is intact.
Clean the lens surfaces with a blower and
soft lens cloth.
Let the sight dry by leaving it in a warm
environment for 4 hours.
Adjust the image by rotating the focusing
ring.
Dust and condensate are covering the outside
optical surfaces after the sight was brought in
from the cold into a warm environment, for
example.
The objective lens is not focused.
With a crisp image of the
reticle, the image of the
observed target that is at
least 30 m away is blurred.
No Wi-Fi signal or erratic
signal.
The unit is beyond reliable Wi-Fi
range.
There are obstacles between the
unit and the signal receiver
(concrete walls for example).
Place the unit in line-of-sight of the Wi-Fi signal.
Check that the has been securely mounted, riflescope
make sure that the same type and calibre bullets are being
used as when the was initially zeroed; if your riflescope
riflescope was zeroed during the summer, and is now
being used in the winter (or the other way round), a minor
displacement of the aiming point is possible.
The is not mounted riflescope
securely.
The aiming point shifts after
firing rounds. The riflescope
will not focus.
Set up the riflescope according to the instructions given in
the Section “Powering on and image setup” and check the
surfaces of the eyepiece and objective lenses and clean
them if necessary from dust, condensation, frost, etc; to
prevent fogging in cold weather, apply a special anti-fog
solution.
Check focusing of the scope in night conditions.
Wrong settings.The riflescope will not focus.
Check
Corrective action
Problem
There are too many Wi-Fi networks
in the area where the riflescope is
located which may cause signal
interference.
To ensure stable Wi-Fi performance, move the riflescope
to an area with few or no Wi-Fi networks.
The riflescope is not
operating properly due to
firmware update.
Please restore the
original firmware
version.
1) Connect an external power supply or insert batteries
into the riflescope.
2) Hold down simultaneously the REC button and the
controller.
3) Start the riflescope with a brief press of the ON button.
Display will blink two times.
The riflescope is being used in
the daytime.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yukon Photon RT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yukon Photon RT in the language / languages: English, German, French, Italian, Spanish as an attachment in your email.

The manual is 3,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info