654138
18
Zoom out
Zoom in
Previous page
1/48
Next page
1).Transmitting group setup: Set base on the groups of the
controller (GR).
2).Flash mode setup: Set the manual flash(M) mode
through the flash control panel, change the flash output
manually, and trigger th rough the controller's PC
interface or main flash contact. High speed sync or other
TTL functions are not supported (the highest sync speed
is 1/250s or lower).
2.PC interface & Legacy Flash Trigger
PC interface (input) trigger: Use LS-PC/PC cable (option)to
connect the controller and the PC interface of camera.
Legacy Flash Trigger: Basic flash (Single Contact)
trigger: Install the controller on the camera hot shoe.
Other Trigger Modes
*About the C.FN 04 Legacy Flash Trigger:
Please set this custom function as OFF when using the
TTL triggering. If it could not operate properly when
using the single contact trigger, set as ON.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yongnuo YN-622C-TX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yongnuo YN-622C-TX in the language / languages: English as an attachment in your email.

The manual is 5,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info