733774
32
Zoom out
Zoom in
Previous page
1/33
Next page
62 63
Display
message
Description Action
ERROR
Wrong passcode has been
entered.
Enter the correct PIN passcode.
HOME
The mower is returning to
the charging station.
LOW
BATTERY
Battery power is low.
If the mower fails to automatically return to the
charging station, carry it to the charging station for
charging.
LIFTED
The mower has
been lifted upward.
Check if the grass is too tall (> 60 mm) and cut
the grass with a normal mower before you start
using the mower again.
Check if the mower is free from obstructions.
NO SIGNAL
The mower cannot receive
signals from the boundary
cable.
Check if the LED indicator light is blue (no
interruptions). Refer to the table “Charging
station” at the beginning of this section for error
messages.
Check if the charging station is properly
connected to a power outlet.
Check if the signal of the boundary cable (S1 or
S2) of the mower is the same as the charging
station.
If you are using the mower for the rst time,
bring it close to the boundary cable.
OBSTACLE
A problem occurs
at the obstacle sensors.
Check that the mower is not stuck in the middle
of an obstacle.
Contact after sales service if the problem cannot
be resolved.
OUTSIDE
The mower is outside of
the boundary cable.
Check if the boundary cable is installed properly if
the mower is still inside the mowing area.
Bring the mower back inside the mowing area
and restart the mower.
If the mower runs outside of the boundary cable
at a corner, adjust and enlarge the angle to
exceed 90°.
If the mower constantly runs outside of the
boundary cable at one place, check if there is
a high power cable close to or underneath the
boundary cable. If this is the case, avoid the area
by changing the position of the boundary cable.
Display
message
Description Action
TRAPPED
The mower is trapped.
Remove the mower from the obstacle. This
warning occurs when the collision sensor has
been triggered more than 10 times within a
minute.
RUNNING
The mower is working.
SPARE TIME
No work is assigned
to the mower.
If the mower should be working, restart the
mower.
Program the working periods if necessary.
CRITICAL
SLOPE
The mower has
been tilted.
Check if the slope is too slippery to climb
and make corrections to the mowing area if
necessary.
TURNOVER
The mower is
overturned.
Turn over the mower, bring it to a at area and
restart it.
WAITING
The mower is just about to
enter the sleep mode
because the battery
power is low.
Press any buttons on the control panel.
TROUBLESHOOTINGTROUBLESHOOTING
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yardforce SA800PRO at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yardforce SA800PRO in the language / languages: English as an attachment in your email.

The manual is 6,66 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info