29781
14
Zoom out
Zoom in
Previous page
1/16
Next page
14
If your cassette deck fails to operate normally, check the following table. It lists common operating errors and simple
measures which you can take to correct the problem. If it cannot be corrected, or the symptom is not listed, disconnect the
deck’s power cord and contact your authorized YAMAHA dealer or service center for help.
TROUBLESHOOTING
Fault
Tape doesn’t move in recording or
playback.
REC/PAUSE button fails to function.
Sounds become faint and sometimes
inaudible.
Recorded sound is distorted.
Tape is playing back, but no sound is
heard.
Excessive noise.
Excessive wow (wavering of the
sound).
Tape stops in the middle of recording
or playback.
Fails to record.
Search does not operate.
High frequencies in the playback
sound are emphasized and unpleasant
to listen to, and noise level (hiss) is
also high.
Cause
Power plug is not properly plugged in.
End of tape.
Cassette shell is warped or damaged.
No cassette tape is loaded.
Protective tabs are broken off.
Head is dirty.
Head is magnetized.
Tape is damaged or of poor quality.
Tape is bad (stretched or deformed,
etc.).
Cassette shell is warped.
Recording level is too high.
Faulty connection between deck and
stereo amplifier/receiver.
Head is dirty.
Head is magnetized.
Worn out or poor quality tape.
Connection(s) improperly made.
Affected by external electrical noise.
Dirty capstan, pinch roller, etc., or poor
tape.
Tape is wound unevenly.
Slack tape, or tape spillage wound
around capstan.
REC LEVEL control is set too low.
Protective tabs are broken off.
Recorded section is too short.
Recorded section has low-level portions.
Conversation, etc. has been recorded.
Dolby NR-recorded tape is played back in
OFF position.
Cure
Reinsert plug properly.
Rewind tape or flip it over.
Do not play damaged tapes.
Load a cassette tape.
Change tape or cover protective hole
with adhesive tape.
Clean head.
Demagnetize head using head
demagnetizer.
Change to a different tape.
Replace with a fresh tape.
A warped cassette shell cannot be
fixed. Replace with another tape and
test.
Check input level with peak level meter
and use lower rec level when recording.
Check and secure connections.
Clean head.
Demagnetize head with head
demagnetizer.
Change to better tape.
Check input and output connections
and reinsert properly.
Move away from electrical appliances
(TV, fluorescent light, electric blanket,
etc.).
Clean capstan or pinch roller, or
change to better tape.
Rewind tape.
Remove the wound tape carefully. To
avoid this, insert pencil in hole in
cassette shell and turn to take up slack
in advance.
Adjust REC LEVEL control.
Change tape or cover protective hole with
adhesive tape.
Blank sections must be at least 4 seconds
long.
Playback in appropriate Dolby NR
position.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha KX10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha KX10 in the language / languages: English as an attachment in your email.

The manual is 0,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info