516960
31
Zoom out
Zoom in
Previous page
1/196
Next page
27 En
English
INTRODUCTION
ADDITIONAL
INFORMATION APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
You can use two tuning modes to tune into a desired FM/
AM station:
Frequency tuning mode
You can search or specify the frequency of the desired
FM/AM station automatically or manually (see “FM/AM
tuning operations” on this page).
Preset tuning mode
You can preset the desired FM/AM station in advance, and
then recall the station by specifying the preset group and
number (see “Selecting preset stations” on page 28).
Note
Orient the connected AM loop antenna, or adjust the position of the end
of the indoor FM antenna for the best reception.
1 Press NINPUT l / h repeatedly so that
“TUNER” is displayed on the front panel
display.
2 Press GBAND to select the reception band
(FM or AM).
3 To search the station automatically, press
ITUNING AUTO/MAN’L so that the AUTO
indicator lights up on the front panel display.
To search the station manually, press
ITUNING AUTO/MAN’L again so that the
AUTO indicator disappears from the front
panel display.
If a colon (:) appears on the front panel display,
automatic/manual tuning is not possible. Press
DEDIT PRESET/TUNING to turn the colon (:)
off.
4 To begin automatic tuning, press
FPRESET/TUNING l / h once. To tune
into the desired station manually, press
FPRESET/TUNING l / h repeatedly.
When this unit is tuned into a station, the TUNED
indicator lights up and the frequency of the received
station is shown on the front panel display.
To tune into a higher frequency, press
FPRESET/TUNING h.
To tune into a lower frequency, press FPRESET/
TUNING l.
Note
If the signal from the station you want to select is weak, tune into it
manually.
Use this feature to store up to 40 stations (A1 to E8: 8
preset station numbers in each of 5 preset station groups).
Preset the desired stations to this unit by using the
automatic or manual station preset.
You can use the automatic preset tuning feature to store up
to 40 FM stations with strong signals in order.
1 Press NINPUT l / h repeatedly so that
“TUNER” is displayed on the front panel
display.
2 Press GBAND to select “FM” as the
reception band.
3 Press and hold HMEMORY for more than 3
seconds.
The preset station number as well as the MEMORY
and AUTO indicators flashes. After approximately 5
seconds, automatic presetting status from the current
frequency and proceeds toward the higher
frequencies.
When automatic preset tuning is completed, the front
panel display shows the frequency of the last preset
station.
y
You can select the preset station group and the preset station number
where the first received station will be stored by pressing EA/B/C/D/E
and then FPRESET/TUNING l / h.
Notes
Any stored station data existing under a preset station number is cleared
when you store a new station under the same preset station number.
Only FM stations with sufficient signal strength are stored automatically
by automatic preset tuning. If the station you want to store is weak in
signal strength, tune it manually and store it as described in “Manual
station preset” on page 28.
Only Radio Data System broadcasting station are stored automatically by
automatic preset tuning (Europe model only).
FM/AM tuning
Overview
FM/AM tuning operations
AUTO
A
AM
1440 kHz
Lights up during automatic tuning
No colon (:)
Preset FM/AM stations
Automatic station preset
AUTO
MEMORY
A1:FM 87.50MHz
Flashes
Flashes
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha HTR-6230 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha HTR-6230 in the language / languages: Italian, Spanish as an attachment in your email.

The manual is 2,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha HTR-6230

Yamaha HTR-6230 User Manual - English - 100 pages

Yamaha HTR-6230 User Manual - English, German, Dutch, French, Swedish - 244 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info