48730
56
Zoom out
Zoom in
Previous page
1/64
Next page
55
1.2.23 RPN (Registered Parameter Number)LSB
(Control #100)
RPN (Registered Parameter Number)MSB
(Control #101)
Messages which offset, or add or subtract values from a Part's pitch
bend sensitivity, tuning, or other parameter settings.
First send the RPN MSB and RPN LSB to specify the parameter which
is to be controlled. Then use 1.2.21 Data Increment/Decrement to set
the value of the specified parameter.
Note that once the RPN has been set for a channel, subsequent data
entry will be recognized as the same RPN's value change. Therefore
after you use the RPN, you should set a Null (7FH, 7FH) value to avoid
an unexpected result.
The following RPN numbers can be received.
1.2.24 Channel Mode Messages
The following Channel Mode Messages can be received.
1.2.24.1 All Sounds Off (Control #120)
Clears all sounds currently sounding on the specified channel.
However, the status of channel messages such as Note On and Hold
On is maintained.
2nd BYTE 3rd BYTE MESSAGE
120 0 All Sounds Off
121 0 Reset All Controllers
123 0 All Notes Off
126 0 ~ 16 Mono
127 0 Poly
RPN MSB RPN LSB PARAMETER
00 00 Pitch Bend Sensitivity
00 01 Fine Tune
00 02 Coarse Tune
7F 7F Null
NRPN MSB NRPN LSB PARAMETER
01 08 Vibrato Rate
01 09 Vibrato Depth
01 0A Vibrato Delay
01 20 Filter Cutoff Frequency
01 21 Filter Resonance
01 63 EG Attack Time
01 64 EG Decay Time
01 66 EG Release Time
14 rr Drum Filter Cutoff Frequency
15 rr Drum Filter Resonance
16 rr Drum EG Attack Rate
17 rr Drum EG Decay Rate
18 rr Drum Pitch Coarse
19 rr Drum Pitch Fine
1A rr Drum Level
1C rr Drum Pan
1D rr Drum Reverb Send Level
1E rr Drum Chorus Send Level
1F rr Drum Variation Send Level
*rr = Note number for each drum voice instrument.
1.2.24.2 Reset All Controllers (Control #121)
The values of the following controllers will be reset to the defaults.
1.2.24.3 All Notes Off (Control #123)
Clears all notes currently on for the specified channel.
However, if Hold1 or Sostenuto is on, notes will continue sounding
until these are turned off.
1.2.24.4 Mono (Control #126)
Performs the same function as when an All Sounds Off message is
received, and if the 3rd byte (mono number) is in the range of 0 - 16,
sets the corresponding channel to Mono Mode (Mode 4 : m = 1).
1.2.24.5 Poly (Control #127)
Performs the same function as when an All Sounds Off message is
received, and sets the corresponding channel to Poly Mode (Mode 3).
1.3 Program Change
Messages which determine which voice to select for each Part.
With a combination of Bank Select, you can select not only basic
voice numbers, but also variation voice bank numbers.
1.4 Channel Aftertouch
Messages which let you control the sounds by the pressure you
apply to the keys after the initial striking of the keys, over the entire
channel.
1.5 Polyphonic Key Pressure
Messages which let you control the sounds by the pressure you
apply to the keys after the initial striking of the keys, for each
individual key.
1.6 Pitch Bend
Pitch Bend messages are continuous controller messages that allow
the pitch of designated notes to be raised or lowered by a specified
amount over a specified duration.
CONTROLLER VALUE
Pitch Bend Change 0 (center)
Aftertouch 0 (off)
Modulation 0 (off)
Foot Controller 0 (min)
Expression 127 (max)
Hold1 0 (off)
Portamento 0 (off)*
Sostenuto 0 (off)
Soft Pedal 0 (off)
Portamento Control Cancels the Portamento source key number
RPN Number not specified; internal data will not change
NRPN
* In Performance mode, 1 (on).
Number not specified; internal data will not change
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CS1X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CS1X in the language / languages: English as an attachment in your email.

The manual is 1,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CS1X

Yamaha CS1X User Manual - German - 196 pages

Yamaha CS1X User Manual - Dutch - 64 pages

Yamaha CS1X User Manual - French - 60 pages

Yamaha CS1X User Manual - Portuguese - 93 pages

Yamaha CS1X User Manual - Spanish - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info