48730
55
Zoom out
Zoom in
Previous page
1/64
Next page
54
1.2.8 General Purpose 1, 2, 3, 4
(Control #016, 017, 018, 019)
Control #016 are messages which are transmitted by operating the
connected Foot Controller, used to control specific parameter such as
voice parameters and Variation effect parameters. Control #017 and
Control #018 are messages which are transmitted by operating the
ASSIGN1 and ASSIGN2 knobs, respectively. Control #019 is undefined.
1.2.9 Hold1 (Control #064)
Messages which control sustain on/off.
Setting the value between 64 - 127 turns the sustain on, between 0 -
63 turns the sustain off.
1.2.10 Portamento Switch (Control #065)
Messages which control portamento on/off.
Setting the value between 64 -127 turns the portamento on, between
0 - 63 turns the portamento off.
1.2.11 Sostenuto (Control #066)
Messages which control sostenuto on/off.
Holding specific notes and then pressing and holding the sostenuto
pedal will sustain those notes as you play subsequent notes, until
the pedal is released.
Setting the value between 64 -127 turns the sostenuto on, between 0
- 63 turns the sostenuto off.
1.2.12 Soft Pedal (Control #067)
Messages which control soft pedal on/off.
Notes played while holding the soft pedal will be dampened.
Setting the value between 64 -127 turns the soft pedal on, between 0
- 63 turns the soft pedal off.
1.2.13 Harmonic Content (Control #071)
Messages which adjust the filter resonance set for each voice.
The value set here is an offset value which will be added to or
subtracted from the voice data.
Higher values will result in a more characteristic, resonant sound.
Depending on the voice, the effective range may be narrower than
the range available for adjustment.
1.2.14 Release Time (Control #072)
Messages which adjust the EG release time set for each voice.
The value set here is an offset value which will be added to or
subtracted from the voice data.
1.2.15 Attack Time (Control #073)
Messages which adjust the EG attack time set for each voice.
The value set here is an offset value which will be added to or
subtracted from the voice data.
1.2.16 Brightness (Control #074)
Messages which adjust the filter cutoff frequency set for each voice.
The value set here is an offset value which will be added to or
subtracted from the voice data.
Lower values will result in a softer sound.
Depending on the voice, the effective range may be narrower than
the range available for adjustment.
1.2.17 Portamento Control (Control #084)
Messages which apply a portamento between the currently-
sounding note and the subsequent note.
Portamento Control is transmitted specifying the note-on key of the
currently-sounding note.
Specify a Portamento Source Key number between 0 - 127.
When a Portamento Control message is received, the currently
sounding pitch will change with a Portamento Time of 0 to the next
note-on key on the same channel.
For example, the following settings would apply a portamento from
note C3 to C4.
90H 3CH 7FH C3 Note on
B0H 54H 3CH Source key number set to C3
90H 48H 7FH C4 Note on (When C4 is on, C3 is raised by a
portamento to C4.)
1.2.18 Effect1 Depth (Reverb Send Level) (Control #091)
Messages which adjust the send level for the Reverb effect.
1.2.19 Effect3 Depth (Chorus Send Level) (Control #093)
Messages which adjust the send level for the Chorus effect.
1.2.20 Effect4 Depth (Variation Effect Send Level)
(Control #094)
Messages which adjust the send level for the Variation effect.
If Variation effect uses System effect, this message sets the send
level for the Variation effect. If it uses Insertion effect, this setting is
invalid.
1.2.21 Data Increment (Control #096)
Decrement (Control #097) for RPN
Messages which increase or decrease the MSB value of pitch bend
sensitivity, fine tune, or coarse tune in steps of 1. You are required to
assign one of those parameters using the RPN in the external device
in advance.
The data byte is ignored.
When the maximum value or minimum value is reached, the value
will not be incremented or decremented further.
(Incrementing the fine tune will not cause the coarse tune to be
incremented.)
1.2.22 NRPN (Non-Registered Parameter Number)LSB
(Control #098)
NRPN (Non-Registered Parameter Number)MSB
(Control #099)
Messages which adjust a voice's vibrato, filter, EG, drum setup or
other parameter settings.
First send the NRPN MSB and NRPN LSB to specify the parameter
which is to be controlled. Then use 1.2.4 Data Entry to set the value of
the specified parameter.
Note that once the NRPN has been set for a channel, subsequent
data entry will be recognized as the same NRPN's value change.
Therefore, after you use the NRPN, you should set a Null (7FH, 7FH)
value to avoid an unexpected result.
The following NRPN numbers can be received.
55


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CS1X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CS1X in the language / languages: English as an attachment in your email.

The manual is 1,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CS1X

Yamaha CS1X User Manual - German - 196 pages

Yamaha CS1X User Manual - Dutch - 64 pages

Yamaha CS1X User Manual - French - 60 pages

Yamaha CS1X User Manual - Portuguese - 93 pages

Yamaha CS1X User Manual - Spanish - 64 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info