557316
23
Zoom out
Zoom in
Previous page
1/48
Next page
Setup Procedures
Additional DriveReplacing Drive
14
7
Remove the four screws holding the CD-ROM drive in place, then
slide the drive forward and out of the drive bay.
Before removing the CD-ROM drive from the computer, make
sure that all the cables have been removed from the CD-ROM
drive’s rear panel.
n Do not force pulling or apply excessive force to the CD-ROM drive.
About IDE 2
Yamaha recommends one of the following connections.
Example-2: As secondary master
If you disconnect the IDE
device and re-connect it to
another location, other
devices connected to the
IDE cable may become slow
in processing, unstable, or
inoperative.
If the 40-pin IDE cable has
only one connector available
but you wish to re-connect
the IDE device (that you just
disconnected) to another
location, use a 40-pin IDE
cable that has two
connectors.
If you connect only one IDE
device to an IDE cable,
assign the device as a
master and connect it to the
end of the cable.
Example-1: As secondary slave
IDE cable (Secondary)
No Device
(slave)
Connect
CRW2100E
IDE cable (primary)
CD-ROM Drive etc.
(slave)
Hard Disk
(master)
(master)
IDE cable (primary)
IDE cable (Secondary)
Connect
CRW2100E
(slave)
Hard Disk
(master)
Hard Disk
(slave)
CD-ROM Drive etc.
(master)
n The CRW2100E drive is shipped with the SLAVE setting. Reset to MASTER if
you connect the drive solely to the secondary IDE cable.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CRW-2100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CRW-2100 in the language / languages: English as an attachment in your email.

The manual is 3,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info