557316
22
Zoom out
Zoom in
Previous page
1/48
Next page
Setup Procedures
Additional DriveReplacing Drive
13
6 Disconnect all the cables connected to the rear of the
existing CD-ROM drive, and also disconnect the audio cable
from the sound card or motherboard’s audio connector.
n The existing CD-ROM drive in the computer is assumed to be an
IDE-type.
ANALOG
AUDIO
CABLE SELECT
SLAVE
MASTER
POWER
HOST INTERFACE
1
2
39
40
+5V
G
G
+
12
V
RLG
G
Audio cable
IDE cable
4-pin power connector
About IDE 1
IDE (Enhanced IDE/E-IDE) is one of the standards applied to the
connection between personal computers and their peripherals. A
computer motherboard provides two IDE connectors (primary and
secondary). (Although, some motherboards provide only a primary
connector.) You may connect up to two IDE devices (hard disk, CD-
ROM, or CD-R drives) to the connectors using an IDE cable. One of the
devices connected via the IDE cable is called “master” and the other
called “slave.”
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CRW-2100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CRW-2100 in the language / languages: English as an attachment in your email.

The manual is 3,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info