18179

Yamaha CDRD651 Manual

31
Zoom out
Zoom in
Previous page
1/33
Next page
E-30
ADDITIONAL INFORMATION ...................................................
Troubleshooting
If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple
measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power
cord and contact your authorized YAMAHA dealer or service center for help. When talking to the service center, the CDR-
D651 may be needed. For details, contact your authorized YAMAHA dealer or service center.
SYMPTOM
The unit does not
switch on when
POWER is pressed.
Play does not begin.
Play is delayed, or
begins at the wrong
place.
Recording is not
possible.
Cannot play back a
recorded CD-R or CD-
RW disc on other CD
or DVD players.
Sound “skips.”
Sound “hums.”
Noise from inside of
the unit.
The remote control
does not work.
TV functions strangely
when the remote
control is being used.
CAUSE
The AC power cord is not connected or not
completely connected.
The disc is damaged.
There is moisture on the laser pick-up.
The disc has been loaded upside down.
The disc is dirty.
The disc may be scratched or damaged.
The disc is finalized.
A pre-mastered CD is loaded.
The input setting is incorrect.
The output level of the source is too low.
There is not enough blank space left or 99
tracks have already been recorded on the
disc.
If the power cord was unplugged or there
was a power outage during recording, the
recorded material may be lost.
The disc is dirty or damaged.
The CD or DVD players are not compatible
with CD-R or CD-RW discs.
The disc is not finalized.
The unit and/or the component being
recorded is being subjected to vibration or
impact.
The disc is dirty.
Improper cable connections.
The disc may be warped.
The batteries of the remote control are too
weak.
Remote control is too far away or is being
used at an incorrect angle.
Direct sunlight or lighting (of an inverter
type of fluorescent lamp, etc.) is striking
the remote control sensor of the unit.
Remote control is being used near TV set
with a remote control sensor.
REMEDY
Securely connect the power cord.
Check the disc carefully; replace it if necessary.
Wait 20 to 30 minutes after switching the unit on
before trying to play a disc.
Reload the disc with the label side facing up.
Clean the disc.
Check the disc carefully; replace it if necessary.
Load a recordable CD that has not been
finalized yet. For a CD-RW disc, TOC Erase or
Disc Erase may be needed.
Load a recordable CD.
Set INPUT to the position that reflects the source
of the input signal.
Set the output level of the source to MAX.
Load a recordable CD.
If the recording of a CD-RW disc is interrupted,
try recording again from the beginning. When
the recording of a CD-R disc is interrupted, start
recording over again with a disc that can be
recorded on.
Clean or replace the disc.
Use a CD or DVD player compatible with CD-R
or CD-RW discs.
Finalize the disc.
Relocate the unit(s). This is not possible if the
skipping sound is already on the recording due
to vibrations or impact that occurred during
recording.
Clean the disc.
Securely connect the audio cables. If the
problem persists, the cables may be defective.
Replace the disc.
Replace the batteries with new ones.
Use within 6 meters and 60 degree radius.
Change the position of the unit.
Relocate this unit away from the TV or cover the
TV’s remote control sensor.
… 31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CDRD651 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CDRD651 in the language / languages: English as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CDRD651

Yamaha CDRD651 User Manual - English, German, Dutch, French, Italian, Swedish, Spanish - 219 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info