18179

Yamaha CDRD651 Manual

29
Zoom out
Zoom in
Previous page
1/33
Next page
E-28
ADDITIONAL INFORMATION ...................................................
CD-Recorder System Notes and
Limitations
■ About track length and number
• The CD specifications state that the minimum length of a
CD track must be 4 seconds. If a recording is stopped
while the track is less than 4 seconds long, the unit will
record silence until the 4 second track length
requirement has been reached, and then stop recording.
• CDs can be recorded with up to 99 tracks on them.
Recording will be automatically stopped if the 99 track
limit is exceeded. Once 99 tracks have been recorded,
no further recording is possible even if time is remaining
on the disc.
■ About source sampling rate conversion
When recording an analog source (such as an LP or
cassette), this unit converts the analog signals to a 44.1 kHz
digital signal before recording them onto the CD-R or CD-
RW disc.
When recording a digital source, this unit converts the
digital signals to 44.1 kHz for recording onto the CD-R or
CD-RW disc. This unit can record 32, 44.1 and 48 kHz
digital signals.
■ When making digital recordings from DAT
When recording from a DAT source, make sure that the start
IDs on DAT tapes are in positions slightly before the actual
audio begins.
DAT tapes that are originally recorded using the DAT
recorder’s auto ID function record the start ID slightly after
the actual recording begins. Because this recorder uses the
start ID on the DAT to indicate the transition between tracks,
the following problems may occur during synchronized
recording (single track or ALL track).
• The beginning of the audio on a track is not recorded.
• A new track number is created slightly after the
beginning of a new track.
• The beginning of the next track is recorded at the end
of a recording.
To avoid these potential problems, it is recommended to
perform manual recording of DAT sources. For more
information on DAT operations, refer to the operating
instructions provided with the DAT recorder.
■ When making a digital copying from a DTS-
CD
Select CD DIRECT mode to make a digital copying from a
DTS-CD.
SCMS Copy Protection
As a digital audio component, this CD recorder conforms
with the Serial Copy Management System (SCMS)
standards. The Serial Copy Management System restricts
copies made by recording digital signals to first generation
copies only.
● Rule 1
You can record digital program sources onto a
recordable CD disc using a DIGITAL IN jack to create a
first generation digital copy. You cannot, however,
record from this recorded CD disc to another recordable
CD disc using a DIGITAL IN jack.
● Rule 2
A CD disc that was recorded using the ANALOG jacks
can be recorded onto other digital recording media
using a DIGITAL OUT jack to create a first generation
digital copy. You cannot, however, make a second
generation copy using a DIGITAL OUT jack.
Second generation digital copy cannot be made because
this unit is designed to conform with SCMS standards.
However, when second generation digital copy is not
possible, this unit automatically changes the setting to
analog recording to complete recording.
In this case, set “SCMS Mode” in the set menu to ANALOG
Copy. (See page 11.)
Before setting the recording level by using the ANALOG
REC LEVEL knob, start the source CD on the disc tray A
first, and then press REC for the disc tray B.
■ Recording of non-audio signals
This unit is designed exclusively for recording audio
signals. Non-audio signals from sources such as CD-ROM
cannot be recorded. Recording is possible only when the
input digital signal is an audio signal. Similarly when a
digital signal contains graphic or character information such
as a CD+graphics disc, the graphic or character
information is not recorded.
ADDITIONAL INFORMATION
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha CDRD651 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha CDRD651 in the language / languages: English as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha CDRD651

Yamaha CDRD651 User Manual - English, German, Dutch, French, Italian, Swedish, Spanish - 219 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info