652727
13
Zoom out
Zoom in
Previous page
1/114
Next page
TROUBLESHOOTING
11 En
English
Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions below do not help, turn off this unit,
disconnect the power cable, and then contact the nearest authorized Yamaha dealer or service center.
TROUBLESHOOTING
Problem Cause Solution See page
This unit fails to turn on. The power cable is not connected or the plug is not completely
inserted.
Connect the power cable firmly.
6
The protection circuitry has been activated because of a short
circuit, etc.
Check that the speaker wires are not touching each other and then turn the
power of this unit back on.
6
There is a problem with the internal circuitries of this unit. Disconnect the power cable and contact the nearest authorized Yamaha
dealer or service center.
-
A speaker with a low impedance is connected. Use speaker(s) with proper speaker impedance (6 or higher).
6
This unit turns off suddenly and the power
indicator turns off.
The speaker wires are touching each other or shorting out against
the rear panel.
Connect the speaker cables properly and turn the power on again. Confirm
normal sound output from speakers after the unit is turned on.
6
The speaker is malfunctioning. Replace the speaker set and turn the power on again. Confirm normal
sound output from speakers after the unit is turned on.
-
This unit has been exposed to a strong external electric shock (such
as lightning or strong static electricity).
Turn off this unit, disconnect the power cable, plug it back in after 30
seconds, then use the unit normally.
-
There is a problem with the internal circuitries of this unit. Disconnect the power cable and contact the nearest authorized Yamaha
dealer or service center.
-
No sound. Headphones are connected.
(When headphones are connected, no sound comes from the
speakers or subwoofer.)
Disconnect headphones when you use the speakers or subwoofer.
-
Incorrect cable connections. Connect the stereo cable for audio units and the speaker wires properly. If
the problem persists, the cables may be defective.
5
Playback has been stopped on the connected component. Turn the component on and start playback.
7
(A-U670 only) The driver is not installed in the PC connected with
the unit via USB.
Before connecting a PC to this unit, install the driver on the PC.
8
The volume of the unit is set to the minimum. Turn up the volume with the VOLUME control so that you can hear
sound.
-
The unit cannot be turned off. The internal microprocessor is frozen due to an external electronic
shock (lightning, excessive static electricity, etc.) or decrease in the
power supply voltage.
Press the power button on the front panel of the unit for 10 seconds or
more to restart the unit (If the problem persists, unplug the power cable
and after about 30 seconds, then plug it back in again).
-
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha A-670 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha A-670 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 11,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info