674754
24
Zoom out
Zoom in
Previous page
1/156
Next page
Page 22 FT DX 9000D OPERATION MANUAL
METER Switch
This control switch determines the function of the
Main Meter during transmission.
COMP: Indicates the RF speech compressor
level (SSB modes only).
PO: Indicates the power output level.
SWR: Indicates the Standing Wave Ratio (For-
ward: Reflected).
IDD: Indicates the final amplifier drain cur-
rent.
MIC LVL: Indicates the relative microphone level.
MONI (Monitor) Switch
This button enables the transmit (RF) monitor in all
modes (except CW, in which the monitor function
is always on, to produce the sidetone). While acti-
vated, the LED in this button glows red. Adjustment
of the Monitor level is accomplished using the
MONI knob, located just to the right of the
MONI switch.
Advice
When using headphones, the Monitor is highly use-
ful for making adjustments to the Parametric Equal-
izer or other voice quality adjustments, because the
voice quality heard in the headphones is such a “natu-
ral” reproduction of the transmitted audio quality.
MONI PITCH Knobs
MONI Knob
The inner MONI knob adjusts the audio level of the
transmit RF monitor during transmission (relative to the
AF GAIN control), when activated by the MONI but-
ton (above).
PITCH Knob
The outer PITCH knob selects your preferred CW
tone pitch (from 300 ~ 1000 Hz, in 50 Hz increments).
The Tx sidetone, receiver IF passband, and display off-
set from the BFO (carrier) frequency are all affected
simultaneously. The Pitch control setting also affects
the operation of the CW Tuning Indicator, as the center
frequency of the CW Tuning Indicator will follow the
setting of this control.
AGC ATT Knobs
AGC Knobs
This switch selects the AGC characteristics for the Main
(VFO-A) band receiver.
ATT Knobs
This switch selects the degree of attenuation, if any, to
be applied to the Main (VFO-A) receiver input.
Advice
The Attenuator may be used in conjunction with the IPO
switch (# above) to provide two stages of signal re-
duction when an extremely strong signal is being re-
ceived.
FRONT PANEL CONTROLS
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-DX9000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-DX9000 in the language / languages: English as an attachment in your email.

The manual is 25,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info