478504
113
Zoom out
Zoom in
Previous page
1/132
Next page
Page 111FT-950 OPERATING MANUAL
032 GENE uT DIAL
Function: Selects the µ-TUNE mode.
Available Values: StP1/StP2
Default Setting: StP1
StP1: Activates the µ-TUNE system using “COARSE”
steps of the
[
SELECT
(
µ-TUNE
)]
knob (2 steps/
click) on the 7 MHz and lower amateur bands. On
the 10/14 MHz bands, “FINE”
[
SELECT
(
µ-
TUNE
)]
knob steps will be used (1 step/click).
StP2: Activates the µ-TUNE system using “FINE” steps
of the
[
SELECT
(
µ-TUNE
)]
knob (1 step/click) on
the 14 MHz and lower amateur bands.
ADVICE:
If an optional RF µTuning Kit is not connected, this ad-
justment has no effect.
033 GENE MIC SCN
Function: Enables/disables scanning access via the
microphone’s
[
UP
]
/
[
DWN
]
keys.
Available Values: On/OFF
Default Setting: On
034 GENE SCN RSM
Function: Selects the Scan Resume mode.
Available Values: CAr/5SEc
Default Setting: 5SEc
CAr: The scanner will hold until the signal disappears,
then will resume after one second.
5SEc: The scanner will hold for five seconds, then resume
whether or not the other station is still transmitting.
035 GENE FRQ ADJ
Function: Adjusts the reference oscillator.
Available Values: –25 ~ 0 ~ +25
Default Setting: 0
Connect a 50-Ohm dummy load and frequency counter to
the antenna jack; adjust the
[
CLAR/VFO-B
]
knob so that
the frequency counter reading is same as the VFO fre-
quency while pressing the PTT switch.
ADVICE:
Do not perform this Menu item unless you have a high
performance frequency counter. Perform this Menu item
after aging the transceiver and frequency counter suffi-
ciently (at least 30 minutes).
MODE-AM GROUP
036 A3E MICGAIN
Function: Sets the microphone gain for the AM mode.
Available Values: Ur/0 ~ 100
Default Setting: Ur
When this menu is set to “Ur”, you may adjust the micro-
phone gain using the front panel’s
[
MIC GAIN
]
knob.
MODE-CW GROUP
037 A1A F-TYPE
Function: Selects the desired keyer operation mode for
the device connected to the front panel’s KEY jack.
Available Values: OFF/buG/ELE/ACS
Default Setting: ELE
OFF: Disables the front panel’s keyer (“straight key” mode
for use with external keyer or computer-driven key-
ing interface).
buG: Mechanical “bug” keyer emulation. One paddle pro-
duces “dits” automatically, while the other paddle
manually produces “dahs”.
ELE: Iambic keyer with ACS (Automatic Character Spac-
ing) disabled.
ACS: Iambic keyer with ACS (Automatic Character Spac-
ing) enabled.
038 A1A F-REV
Function: Selects the keyer paddle’s wiring configuration
for the KEY jack on the front panel.
Available Values: nor/rEV
Default Setting: nor
nor: Tip = Dot, Ring = Dash, Shaft = Ground
rEV: Tip = Dash, Ring = Dot, Shaft = Ground
039 A1A R-TYPE
Function: Selects the desired keyer operation mode for
the device connected to the rear panel’s KEY jack.
Available Values: OFF/buG/ELE/ACS
Default Setting: ELE
OFF: Disables the front panel’s keyer (“straight key” mode
for use with external keyer or computer-driven key-
ing interface).
buG: Mechanical “bug” keyer emulation. One paddle pro-
duces “dits” automatically, while the other paddle
manually produces “dahs”.
ELE: Iambic keyer with ACS (Automatic Character Spac-
ing) disabled.
ACS: Iambic keyer with ACS (Automatic Character Spac-
ing) enabled.
040 A1A R-REV
Function: Selects the keyer paddle’s wiring configuration
for the KEY jack on the rear panel.
Available Values: nor/rEV
Default Setting: nor
nor: Tip = Dot, Ring = Dash, Shaft = Ground
rEV: Tip = Dash, Ring = Dot, Shaft = Ground
MENU MODE
GENERAL GROUP
113


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-950 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-950 in the language / languages: English as an attachment in your email.

The manual is 6,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info