478504
43
Zoom out
Zoom in
Previous page
1/132
Next page
Page 41FT-950 OPERATING MANUAL
ATT
When extremely strong local signals or high noise, still degrades reception, you can use the
[
ATT
]
button to insert 6, 12, or
18-dB of RF attenuation in front of the RF amplifier.
1. Press the
[
ATT
]
button several times to set the desired
attenuation level, per the chart below.
: Attenuator is Off
: The incoming signal power is reduced by 6
dB (Signal voltage reduced by 1/2)
: The incoming signal power is reduced by 12
dB (Signal voltage reduced to 1/4)
: The incoming signal power is reduced by 18
dB (Signal voltage reduced to 1/8th)
The selected attenuation level will be indicated in the
ATT column of the Block Diagram Display on the dis-
play.
2. To restore full signal strength through the Attenuator
circuit area, press the
[
ATT
]
button to restore the ATT
display to the “OFF” position.
Block Diagram Display
ADVICE:
The attenuator selection will be memorized independently on each VFO stack of the VFO-A and VFO-B.
If background noise causes the S-meter to deflect on clear frequencies, press the
[
ATT
]
button until the S-meter drops
to about “S-1”. This setting optimizes the trade-offs between sensitivity, noise, and interference immunity. Also, once
you have tuned in a station you want to work, you may want to reduce sensitivity further (add more attenuation) by
pressing the
[
ATT
]
button to a higher setting. This reduces the strength of all signals (and noise) and can make reception
more comfortable, important especially during long QSOs. When looking for weak signals on a quiet band, you will
want maximum sensitivity, so the IPO should be disabled and the
[
ATT
]
button should be set to “OFF.” This situation is
typical during quiet times on frequencies above 21 MHz, and when using a small or negative-gain receiving antenna on
other bands.
INTERFERENCE REJECTION
[
ATT
]
Button
BLOCK DIAGRAM DISPLAY
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-950 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-950 in the language / languages: English as an attachment in your email.

The manual is 6,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info