610813
296
Zoom out
Zoom in
Previous page
1/328
Next page
Troubleshooting
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
General Care and Troubleshooting
296
Troubleshooting Tips
If you are experiencing difficulties using your device, check the suggestions below for problem solving
advice:
Problem Potential Solution
The device will not power on Check to see that the device is not in Energy Saver mode as indicated by
the green light on the control panel. Touch the User Interface screen to
re-activate.
•Press the ON/OFF button.
Check to see if the power cord is correctly installed.
Documents will not feed
through the document feeder
Ensure that all staples or paper clips have been removed from the
originals.
•Ensure the document feeder is not overloaded. The document feeder
can hold 75 sheets (35 model only) or 100 sheets (all other models) of
80 gsm (20 lb) paper. Use Build Job if you have more originals than this.
Check to see if the document set is fully inserted into the document
feeder.
Ensure that the edge guides are adjusted to touch the sides of the
originals.
Ensure that the document feeder Feed Head is installed correctly. Open
the top cover and push feed head down into position.
Check for obstructions or paper debris in the document feeder.
Ensure that the document feeder cover is closed.
Check that the device is Ready as indicated by a message on the touch
screen.
Repeated paper jams, misfeeds
or multisheet feeds
Ensure that the correct paper size is displayed on the touch screen.
Ensure that the paper tray is not filled above the MAX line.
Ensure that the edge guides are adjusted to touch the sides of the
paper.
If the problem is not resolved, check for obstructions where paper enters
the device.
Paper Jams inside the device Check the Paper Path for obstructions.
Ensure all the handles and levers are in the correct (home) position. The
red flashes behind the jam clearance handles and levers should not be
visible. Follow the instructions displayed on the touch screen.
Flip the paper over in the paper tray.
Check the paper tray Edge Guides to see if they are against the edges of
the paper.
Check that the touch screen is displaying the correct size for the paper
in use.
Load fresh paper.
Repeated Check Tray messages
on the touch screen and the
paper is loaded in the tray
Adjust the edge guides against the stack of paper in the tray.
If the edge guides were not set against the paper in the tray when Start
was selected, delete the job in the job queue and begin again.
296


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xerox WorkCentre 5775 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xerox WorkCentre 5775 in the language / languages: English as an attachment in your email.

The manual is 7,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Xerox WorkCentre 5775

Xerox WorkCentre 5775 User Manual - German - 326 pages

Xerox WorkCentre 5775 User Manual - Dutch - 338 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info