684723
17
Zoom out
Zoom in
Previous page
1/22
Next page
9
EN
Important
Use the correct cable diameter appropriate to length and the current
that will pass through the battery protector (the maximum power of
the connected consumers). Incorrect cable thickness can cause
voltage loss. This will cause the protector to switch off earlier than
desired. Cables that are too thin can also result in overheating.
Formula for calculating the + cable:
current x length in meters x 0.2 = cable thickness in mm2
The minus cable can be 1.5mm2.
*=
adjust the cut-out according to the maximum current consumption of
the connected consumers
After connection with the battery, the protector will switch the output
on or off, depending on the measured battery voltage. See chapter 'In
use'.
Set the desired disconnect voltage upon connection. See chapter
‘disconnect voltage’.
Pre-warning function
This battery protector has the option of issuing a warning signal before
the pre-set disconnect voltage is reached. This point is approximately
0.5/1.0Volt above the pre-set disconnect value (for exact values, see
specifications on page 20). An acoustic (buzzer) or optical signal (light)
can be generated as an indication that the battery is in danger of
Pin 30 = input (battery)
Pin 86 = pre-warning
Pin 85 = Massa/minus
Pin 87 = output (users)
Input (battery)
Output
(
users
)
Pre
-
warning
Ground
/minus
Fuse*
Fuse
3Amp.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xenteq SBP-SERIES at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xenteq SBP-SERIES in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info