724649
15
Zoom out
Zoom in
Previous page
1/18
Next page
AFTER SALES SUPPORTe-mail: help@powertoolsupport.com
1800 909 909 (toll free)MODEL No.: DBAF50/40 • 61420 • 07/2018
AFTER SALES SUPPORTe-mail: help@powertoolsupport.com
1800 909 909 (toll free)MODEL No.: DBAF50/40 • 61420 • 07/2018
28 29
Problem Possible Cause Solution
Safety Striker Pin (1)
does not depress
fully and unit not
operating.
Low on staples or nails.
Safety Striker Pin (1) is jammed.
Re-install nails / staples into magazine.
Remove battery and clean any debris from
the magazine or around the safety striker
pin (1).
Brad nailer / stapler
operates properly
but nails / staples
not firing in full
depth.
Nail / staple is too long for the
contact surface.
Depth adjustment wheel (3) not
set properly
Use appropriate size nail / staples.
Adjust the depth adjustment wheel (3)
to an increased driving depth.
Brad nailer / stapler
operates properly
but nails / staples
ring too deep.
Depth adjustment wheel (3) not
set properly.
Adjust the depth adjustment wheel (3)
to an decreased driving depth.
Brad nailer / stapler
jams frequently.
Nails / staples are incorrect size.
Nails / staples are damaged.
Magazine is loose or dirty.
Check nail / staple size.
Replace the nail/s / staple/s.
Secure magazine.
Brad nailer / stapler
stops and LED light
is ashing red
Nail / staple is jammed. Clean magazine.
Refer to page 25 for xing jams.
Brad nailer / stapler
stops and LED
light is red (but not
ashing).
Battery low on charge. Charge battery.
Brad nailer / stapler
stops and LED light
is ashing green.
Brad nailer / stapler has over-
heated / overloaded.
Refer to page 26 for treating overload
condition.
Brad nailer / stapler
stops and LED light
is green (but not
ashing)
No nails / staples loaded. Install nails / staples
What your 5 year warranty means
Great care has gone into the manufacture of this product and it should
therefore provide you with years of good service when used properly.
In the event of product failure within its intended use over the course of
the rst 5 years after the date of purchase, we will remedy the problem
as quickly as possible once it has been brought to our attention. In the
unlikely event of such an occurrence, or if you require any information
about the product please contact us via our after sales support services,
details of which can be found in this manual and on the product itself.
After Sales Support TEL: 1800 909 909
Service Support
If you have any issues with the operation of your product, please call us on
1800 909 909 for advice, or email us at help@powertoolsupport.com
Accessories and After Sales Parts
The following is available for purchase by visiting https://help.tools/ or
calling our customer service hotline on: 1800 909 909
Replacement nails and staples for use with the Brad Nailer / Stapler
can be purchased at most local hardware stores under various dierent
brands. Ensure the specication of the Nails / Staple does not exceed
the maximum capacity of this product (Max nail length / type: 50mm,
18 gauge brad nail and Max staple length / type: 40mm, 18 gauge light
duty staple).
FAQ/Troubleshooting
* Battery and Charger not included with this product
For further inquiries or issues associated with your Brad Nailer / Stapler, call our
Customer Service on 1800 909 909 or email us at help@powertoolsupport.com
1. Various staple size cartridges 2. Various nail size cartridges
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Workzone TG212T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Workzone TG212T in the language / languages: English as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info