724661
24
Zoom out
Zoom in
Previous page
1/30
Next page
Air Brush Kit
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com 1800 909 909
MODEL: №. TG212 • 07/2017 • 53633 (toll free)
22
AFTER SALES SUPPORT
(toll free)
Air Brush Kit
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. TG212 07/2017 53633
Draining the Water Trap
During normal compressor operation, moisture in the air is also compressed
and then trapped in the clear plastic reservoir directly below the outlet
regulator. The water trap is a means to assist in the separation of the air and
water so excess water is restricted from spraying out with the air and in turn
onto the job being painted.
The amount of water collected in the water trap will depend on the
humidity of the air and the duration the compressor is operating.
It is suggested to check the reservoir every time the compressor is started
and if water has pooled in the base of the reservoir, drain the reservoir.
The collection of water in the reservoir is a normal activity of a compressor.
To drain the water trap, follow these steps:
1. Check the water level in the reservoir (Fig AB)
and if there is ANY pooling of water in the
bottom of the reservoir, depress the drain
release valve (9) at the base of the reservoir (Fig
AC). A flat bladed screw driver is suitable for this
application. The small valve can be lifted by the
small clip on the valve.
NOTE: Water will drip from the tube outlet of
the valve so ensure there is a small container
under the valve to collect the water.
2. If the water does not drip freely from the valve
and still remains in the reservoir, you can turn on
the compressor for a couple of seconds and then
turn the compressor off.
3. Re-open the drain valve on the reservoir as
above, BUT NOTE, the water will spurt a little
from the outlet tube.
4. When you release the drain release valve (9),
the valve will automatically close.
5. Ensure to clean up any excess water discharged
from the drain release valve (9).
AB.
AC.
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Workzone TG212 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Workzone TG212 in the language / languages: English as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info