AUS
AFTER SALES SUPPORT
email: help@powertoolsupport.com
1800 909 909
MODEL: T12VW / T12VWP PRODUCT CODE: 51546 12/2015
Phone lines available Monday to Friday, 8am - 6pm.
AUS
AFTER SALES SUPPORT
email: help@powertoolsupport.com
1800 909 909
MODEL: T12VW / T12VWP PRODUCT CODE: 51546 12/2015
Phone lines available Monday to Friday, 8am - 6pm.
For drilling, always use the Drill position by aligning the Drill symbol
with the triangular indicator on the front face of the drill near the
torque collar (Fig 8).
For setting the torque position, select a low setting on the torque collar
and align the selected symbol with the triangular indicator on the top
of the drill. (See Fig. 9)
Inserting and removing bits
This drill/driver has a keyless chuck (9), which means that a chuck key is
not needed to secure a bit in the drill/driver.
Open the chuck by unscrewing it in an anti-clockwise direction,
holding the drill/driver as shown.
Do this sufficiently enough to allow the drill bit to enter the jaws of
the chuck.
Ensure the drill bit is fully inserted, so that the chuck jaws grip the
straight section of the bit.
Rotate the chuck clock-wise until the jaws tighten on the drill bit. The collar of the chuck
needs to be tightened firmly to ensure the drill bit is held securely. (See Fig. 10)
To remove the drill bit, rotate the chuck sharply in a anti-clockwise direction, suciently
enough to allow the drill bit to be removed.
Note This device is fitted with spindle lock and the chuck is a one handed operation.
Note Operate the chuck by hand only. It is dangerous practice to run the drill/driver to
tighten or loosen the chuck.
Operating Instructions
8
Fig. 9
Fig. 10
