809329
5
Zoom out
Zoom in
Previous page
1/28
Next page
ENERGY MEASUREMENT
6 720 802 172 (2012/06) 5
Fig. 2 Heat pump description
[1] Collector circuit pump
[2] Evaporator
[3] Compressor
[4] Condenser
[5] Heat pump domestic hot water cylinder
[6] Floor heating
[7] Radiator
[8] Heat pump
[9] Heat carrier pump
[10] Expansion valve
[11] Borehole
[12] Geothermal heating coil (horizontal loop/compact collector)
The collector circuit fluid, which is a mixture of water and anti-freeze,
circulates in the borehole/geothermal heating coil in a plastic hose.
The fluid collects stored solar energy and with the help of the collector
circuit pump leads it into the heat pump and to the evaporator. The
temperature is then approximately 0 °C.
In the evaporator the collector circuit fluid meets the refrigerant. The
refrigerant is then in a fluid state and is at approximately -10 °C. When
the refrigerant meets the zero degree heat transfer fluid, it starts to
boil. Vapour forms and is led into the compressor. The temperature of
the vapour is approximately 0 °C
In the compressor, the pressure on the refrigerant increases and the
temperature of the vapour rises to approximately +100 °C. The hot
vapour is then forced into the compressor.
In the condenser the heat is transferred to the house heating system
(radiators and underfloor heating) and the hot water system. The
vapour cools and liquefies. The pressure in the refrigerant is still high
when it is led on to the expansion valve.
The pressure of the refrigerant is reduced in the expansion valve. The
temperature also drops to approximately -10 °C. When the refrigerant
passes the evaporator it changes to vapour again.
The collector circuit is led out from the heat pump to the borehole/
geothermal heating coil to collect new stored solar energy. The
temperature of the fluid is then approximately -3 °C.
6 ENERGY MEASUREMENT
The control unit has the ability to measure the amount of energy that is
produced by the heat pump unit. The calculation assumes that, for
example, the heat pump is correctly installed and that the flow and
temperatures on the hot and cold sides are adjusted as recommended.
The value should therefore be regarded as an estimate of the actual
emitted output. The margin of error in the calculation is normally put at
5-10%.
In addition, the energy output is affected by the outdoor temperature,
the settings for the thermostat and room controls and heat pump usage.
Ventilation, indoor temperature and hot water demand can play a
decisive role.
1 2 3 4 5
6
7
8
11
910
12
6 720 614 540-02.3I
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester Greenstore Ground Source at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester Greenstore Ground Source in the language / languages: English as an attachment in your email.

The manual is 3.44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info