809296
20
Zoom out
Zoom in
Previous page
1/36
Next page
20 6720819898 C 11/2017
INSTALLATION
LOCATION AND SHIELDING OF CONNECTING FLUEPIPES
Connecting uepipes should be used only to connect appliances
to their chimneys. They must not pass through any roof space,
partition, internal wall or oor, except to pass directly into a
chimney through either a wall of the chimney or a oor supporting
the chimney. Connecting uepipes should also be guarded if they
could be at risk of damage or if the burn hazard they present to
people is not immediately apparent.
Connecting uepipes should be located so as to avoid igniting
combustible material. Ways of meeting the requirement include
minimizing horizontal and sloping runs and:
Following the guidance as noted above where the connecting
uepipe is a factory-made metal chimney is at least equal
to designation BS EN 1856-1:2003 and installed to BS EN
15827-1; or
Separation by shielding in accordance with the diagram below:
Elevation
without shield
Elevation
with shield
Plan without
shield
Shields should either:
a) extend beyond the fluepipe by at least 1.5 x D; or
b) make any path betweeb fluepipes and combustible
material at least 3 x D long.
Air space of at least 12mm
between non-combustible
shield and combustible
material
Plan with
shield
Indicates combustible
material
Protecting combustible material from uninsulated uepipes for solid fuel appliances
AIR REQUIREMENTS AND ASSESSING AIR PERMEABILITY OF OLDER DWELLINGS IN RELATION TO
PERMANENT VENTILATION REQUIREMENTS
It is important to note for proper operation, this appliance requires
room air to function efciency. Therefore, a calculation of the air
requirements should be performed before and after installation for
proper and efcient operation of this product.
As a guide, this appliance requires 3410mm² of permanently open
vent in a well-sealed house, but this reduces to 660mm² for a
house with much higher air permeability. It is unlikely that a house
built before 2008 will be well-sealed unless extensive measures
have been taken to improve air tightness.
Older houses are unlikely to have been tested but are unlikely to
achieve an air permeability of less than 5.0 m3/(h.m2) at 50Pa
unless the building fabric has been substantially upgraded.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstyle Hanbury at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstyle Hanbury in the language / languages: English as an attachment in your email.

The manual is 9.09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info