809350
43
Zoom out
Zoom in
Previous page
1/48
Next page
43
Environment / disposal
Sense ll – 6 720 812 775 (2014/10)
Fault affecting the heat source
Locking faults on the heat source can be rectified by
performing a reset.
Reset the heat source.
See the operating instructions of the heat source for additional
information about eliminating faults affecting the heat source.
If the fault cannot be rectified by a reset, contact your
Installer.
10 Environment / disposal
Environmental protection is a fundamental corporate strategy
of the Bosch Group.
The quality of our products, their efficiency and environmental
safety are all of equal importance to us and all environmental
protection legislation and regulations are strictly observed.
We use the best possible technology and materials for
protecting the environment taking into account of economic
considerations.
Packaging
We participate in the recycling programmes of the countries in
which our products are sold to ensure optimum recycling.
All of our packaging materials are environmentally friendly and
can be recycled.
Old electrical and electronic appliances
Electrical or electronic devices that are no
longer serviceable must be collected
separately and sent for environmentally
compatible recycling (in accordance with the
European Waste Electrical and Electronic
Equipment Directive).
To dispose of old electrical or electronic
devices, you should use the return and collection systems put
in place in the country concerned.
Technical terms
Setback phase
A time slot during automatic mode, with Setback operating
mode (a lower background temperature).
Automatic mode
The heating system is heating in accordance with the time
program and an automatic changeover takes place between
operating modes.
Mode
The operating modes for heating are: Heating and Setback.
They are depicted by the symbols and .
For a constant heating circuit only the Auto and Off are
available ( Chapter 5.3.2, page 19).
Operating modes for DHW heating are:DHW, DHW reduced
and Off.
An adjustable temperature is assigned to each operating mode
(except for Off).
Instantaneous water heater (combi boiler)
With this type of DHW heating, DHW is available on demand.
Compared with DHW heating via a DHW cylinder, it can take
longer for the required temperature to be reached at the draw-
taps. This delay can be reduced by activating the keep hot
function ( Temperature maintenance).
Frost protection
Depending on the selected frost protection, the heating pump
will turn on when the outside and/or room temperature reaches
below a certain set threshold. Frost protection prevents the
heating system from freezing up.
Required room temperature (also desired or set
temperature/set room temp.)
The room temperature to be achieved by the heating system. It
can be set individually.
Default setting
Values permanently saved in the programming unit
(e.g. complete time programs) that are available at any time
and that can be reinstated according to demand.
Heating phase
A time slot during automatic mode, where Heating operating
mode is active.
Hybrid device and hybrid system
Heating system comprising heat appliances which complement
one another with integrated optimisation control. Available as
a single unit or separate units (e.g. condensing appliance with
Heat source faults are always displayed on the
heat source.
If there is a BUS connection between the
controller and the heat source, faults are also
displayed on the controller.
If in doubt, ask your Installer about the type of
connection.
43


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstar Sense ll at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstar Sense ll in the language / languages: English as an attachment in your email.

The manual is 4.46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info