809350
42
Zoom out
Zoom in
Previous page
1/48
Next page
42
Eliminate fault
Sense ll – 6 720 812 775 (2014/10)
Faults you can fix yourself
If an operating fault cannot be rectified:
Contact an authorised installer, or customer service.
Submit error code, additional code and control unit ID
number.
Fault
code
Sub-
code
Cause or fault
description Test procedure/Cause Corrective measure
Nothing appears on the display System is switched off. Switch on the system.
The power supply to the controller has been
interrupted.
Check that the controller is
correctly seated in its wall
bracket.
A01 810 DHW stays cold. Check if water is possibly being drawn from the
DHW cylinder constantly due to taps being open.
If water is being drawn
constantly, take action to stop
this.
A01 811 DHW heating: thermal
disinfection failed
Check if water is possibly being drawn from the
DHW cylinder constantly due to taps being open.
Take action to stop water being
drawn constantly.
A11 1010 No communication via
BUS connection EMS 2
Check that the controller is
correctly seated in its wall
bracket.
A11 1038 Invalid time/date Date/time not yet set Set date/time.
Prolonged loss of power supply Avoid voltage failures.
A11 3061
...
3064
No communication with
heating circuit module
(3061: heating
circuit 1, ..., 3064:
heating circuit 4)
Check that the controller is
correctly seated in its wall
bracket.
A11 6004 No communication w.
solar module
Check that the controller is
correctly seated in its wall
bracket.
A21
...
A24
1001 No BUS connection between Sense ll and Sense I
in the corresponding heating circuit (A21:
heating circuit 1, ..., A24: heating circuit 4).
Check that the controller is
correctly seated in its wall
bracket.
A41
A42
4051
4052
Thermal disinfection
failed.
Check if water is possibly being drawn from the
DHW cylinder constantly due to taps being open.
Take action to stop water being
drawn constantly.
H... Maintenance required. The system keeps
operating as far as possible.
Make arrangements to have the
system serviced by your
Servicing Engineer.
H07 1017 Water pressure in the system is too low. This
value is only displayed if your system is equipped
with a digital pressure sensor.
Top up the heating water as
described in the operating
instructions of the heat source.
Table 40
__ _
Table 41 The control unit ID number must be filled in here by the installer at installation.
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstar Sense ll at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstar Sense ll in the language / languages: English as an attachment in your email.

The manual is 4.46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info