IMPORTANT INFORMATION
GREENSTAR HEATSLAVE II EXTERNAL 12/18, 18/25 & 25/32
6 720 805 212a (07.2013)
13
GENERAL
INFORMATION
IMPORTANT INFORMATION
WARNING:
External equipment operating at 230 Volts
must not be serviced or repaired during
adverse weather conditions.
Do not use pressure washers or steam
cleaners on this appliance or cabinet.
FUEL:
This appliance is designed to use 28 second
kerosene, no other fuel must be used.
BOILER LOCATION:
WARNING:
This boiler must not be installed where there
is a potential for excessive ground water
coverage.
To prevent “wetting” it is recommended that the
flue terminal faces away from walls.
Never allow the flue terminal or air inlet to
become obstructed by plants or any other
objects.
This boiler is only suitable for installing externally
at a suitable location onto a fixed, permanent,
rigid surface capable of supporting the boiler
weight. Wood and tarmac hardstandings are not
recommended.
The boiler must be installed on a flat level
surface to ensure that condensate does not
enter the primary heat exchanger.
The cabinet is not load bearing, and only
provides weather protection for the boiler inside.
There must be sufficient hard standing and
access around the boiler for servicing.
INSTALLATION & SERVICING
CLEARANCES
FRONT
FRONT
FRONT
BASE
Plan
view
Plan
view
2500mm
2500mm
2500mm
600mm
600mm
600mm
600mm
50mm
10mm
85mm 45mm
The same applies
for right hand flue
installation where
right and left
clearances are
mirrored.