809256

Worcester-Bosch Greenstar Danesmoor Utility Regular - Utility System Manual

22
Zoom out
Zoom in
Previous page
1/64
Next page
Pre-Installation
Greenstar Danesmoor Utility 2022+ and Utility System 2022+ - 6 721 846 263 (2022/01)22
4.9 Flue options
4.9.1 Conventional flue (CF)
• Open (conventional) flued appliances must not be installed in a
bedroom, bathroom, bed-sitting room, or garage.
• The flue system must be in accordance with BS 5410 : Part 1 and the
current Building Regulations.
• The flue must be constructed of materials suitable for use with
condensing combustion products.
• External flue systems must be of the insulated type.
• Brick and masonry chimneys must be lined with a suitable non -
combustible material and properly jointed to withstand the effects of
the working temperature (minimum rating of material 120°C) of the
appliance and any condensate which may form.
• All flue joints must be sealed to prevent the leakage of condensate
and combustion products.
• Ensure that joints are made so that the condensate runs away and is
not collected within the joint.
CF Sizing:
▶ 12/18 and 18/25 = 100/103mmØ
▶ 25/32 = 130mmØ *
* Unless installing a Worcester Greenstar Oilfit Conventional
Flexible flue.
• Because the flue operates at a lower temperature on a condensing
boiler compared to that of a conventional appliance, the flue draught
will be lower.
Typically the draught will be between 0.5mmwg and 4.4mmwg,
measured with the flue warm but the burner not firing. The actual
figure will vary depending on weather conditions, flue height and
position.
• The flue should be vertical and contain as few bends as possible, a
maximum of two 135° bends should be used.
• The flue outlet must be extended beyond the eaves of the building
and where possible, above the apex.
• Fit a suitable anti down-draught terminal where down draughts are
experienced.
Fig. 26 Conventional flue
[A] Boiler
[B] Stainless steel flue
[C] Max. two bends at 135°
[D] Anti down-draught terminal
[E] Chimney
[F] Height to first bend from top of boiler (min. 600mm)
The flue can be increased in size from the boiler take off
point providing the joint is correctly sealed.
Never reduce the flue diameter from the boiler take off
point.
C
B
A
D
E
6720808218-20.1Wo
F
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstar Danesmoor Utility Regular - Utility System at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstar Danesmoor Utility Regular - Utility System in the language / languages: English as an attachment in your email.

The manual is 14.85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info