697434
54
Zoom out
Zoom in
Previous page
1/72
Next page
Display information
6720813171 (2016/05)54
14.3 BC10 Display settings
14.4 BC10 Display codes
Display settings
Display
setting
Meaning of display setting Unit Range
Factory
adjusted
setting
[l/9/9| Configured target load (50 kW). % [l/3/0| [l/9/9| / [l/-/-| 100 % [l/-/-|
[l/9/9| Configured target load (65 kW). % [l/2/0| [l/9/9| / [l/-/-| 100 % [l/-/-|
[l/9/9| Configured target load (80 kW). % [l/2/5| [l/9/9| / [l/-/-| 100 % [l/-/-|
[l/9/9| Configured target load (100 kW). % [l/2/0| [l/9/9| / [l/-/-| 100 % [l/-/-|
[f/\.5| Configured target value of the pump run-over time.
Note: Do not set a pump run-over time of less than [f/\/5|
(= 5 minutes).
min. [f/0/0| [f/6/0| / [f/1/d| 24 h [f///5|
[c/\/1| DHW supply operating condition setting.
Please note: If the setting [c/\/0| is displayed, the frost protection of
the DHW supply has also been switched off.
Not appli-
cable.
[c/\/0| Off / On [c/\/1|
Table 23 Display settings
Display codes
Display code
LED on
UBA 3 Other effectsz
Main
display
code
z
Sub
display
code
z Key to display code
Reset
requi-
red?
[\/-/\|
Operating phase:
Communication test while starting up. This display code
flashes 5 times within 5 seconds while starting up to
indicate that the communication between the UBA 3 and
the BC10 basic controller is being tested. If a new UBA 3
or a new KIM was fitted, this code will flash for max.
10 seconds.
Off or
flashing
at 8 Hz
[\/-/\|
Fault:
If this code continues to flash on the display, there is a
fault in the communication between the UBA 3 and the
BC10 basic controller.
Off or
flashing
at 8 Hz
e
[-/a/\]
1)
e
[2/0/8|
2)
Operating phase:
The boiler is in flue gas test or service mode.
Off or
flashing
at 8 Hz
No heating operation and no
DHW.
e
[-/h/\|
e
[2/0/0|
2)
Operating phase:
The boiler is in heating mode.
Off
e
[-/h/}
3)
e
[2/0/0|
2)
Operating phase:
The boiler is in manual operation mode.
Off The room temperature is too
high.
e
[=/h/\|
e
[2/0/1|
2)
Operating phase:
The boiler is in DHW mode.
Off
e
[=/h/\|
e
[2/0/1|
2)
Operating phase:
Pump run-over time via the external hot water cylinder
130 seconds at the minimum speed. The “Burner” LED
(On/Off) is off.
Off
e
[0/a/\|
e
[2/0/2|
2)
Operating phase:
The switch optimization program is activated. This
program is activated if there has been any demand more
frequently than once every 10 minutes. This means that
the boiler cannot be restarted until at least 10 minutes
have elapsed since initial burner start-up.
Off The room temperature is not
possibly reached.
e
[0/a/\|
e
[3/0/5|
2)
Operating phase:
The boiler cannot start up temporarily after a DHW
request has ended.
Off
Table 24 Display codes
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch GB162-80 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch GB162-80 in the language / languages: English as an attachment in your email.

The manual is 5,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Worcester-Bosch GB162-80

Worcester-Bosch GB162-80 Installation Guide - English - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info