809312
3
Zoom out
Zoom in
Previous page
1/14
Next page
GENERAL
INFORMATION
ELECTRICAL CONNECTION
A mains cable should be connected to a double pole isolator
with a contact separation of 3 mm on all poles and supplying the
appliance and controls only.
The mains supply for your Danesmoor FS boiler is 230 volts
AC-50Hz.
Your boiler must be earthed and protected by a 5-amp fuse.
FLUE OPTIONS
The Danesmoor FS may be installed onto a Conventional
open flue or a factory made Room sealed balanced flue, the
decision is made by the installing engineer and is dictated mainly
by boiler location.
OPEN-FLUED BOILERS
Your installer will create airways (in walls or doors) to ensure
an adequate supply of fresh air to the boiler for combustion. Do
not block these airways, and never hang clothes or other
combustible materials over the boiler or against the flue pipe.
Never place anything on top of the boiler.
ROOM-SEALED BALANCED FLUE
BOILERS
Air for this type of boiler is supplied via the balanced flue
terminal, and no other air supply is required, except for ventilation
if the boiler is installed in a cupboard or compartment.
3
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Danesmoor FS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Danesmoor FS in the language / languages: English as an attachment in your email.

The manual is 1.21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info