2. Adapt the total installation height to the height of the user. Please note that the
extraction capacity of the appliance can decrease if installed at a large distance to
the hob.
WARNING! Never install the appliance below the required
minimum distance. If you ignore the required minimum distance, the
accumulated fat in the filters can catch fire due to the heat emission of the
hob. RISK OF FIRE!
CAUTION! Any potential user has to be careful not to hit their head on
the corners and edges of the appliance. RISK OF BRUISES! RISK OF
INJURIES IN THE OCULAR AREA!
2.2 Installation steps
WARNING! Failure to install the screws or fixing device in accordance
with these instructions may result in electrical hazards.
WARNING! Do not damage the wiring in the wall while drilling
NOTICE! Two assistants are required for installation.
1. The ceiling must take a weight of at least 120 kg. The ceiling gauge must be at
least 30 mm.
2. Drill a hole with a diameter of 170 mm through the ceiling.
3. Drill 12 holes which have to meet the dimension of the suspension device into
the ceiling (fig. 1).
4. Fix the suspension device with 12 big flathead screws type ST6*40 mm on the
ceiling. Use 8 dowel screws when fixing on a concrete ceiling.
5. Connect the suspension device with 8 screws type M4*10 to the angle irons (fig.
2).
6. Calculate the needed length of the angle irons. Fix the angle irons with 16 big
flathead screws type M4*10 and M4 nuts. An overlapping length of at least 100
mm is required.
7. Insert the extension tube into the 170 mm-hole and lead it outwards (fig. 3).
8. Fix the inside chimney with 4 screws type ST4*8 on the suspension device. Push
the outside chimney on the inside chimney. Use the S-hook to hold the chimney
while installing it.
