638206
20
Zoom out
Zoom in
Previous page
1/202
Next page
20
G
Chain lubrication
1 Caution! The device should be operated
only with adequate chain lubrication oil.
Check the oil level with the help of the oil
level indicator .
3 Tank capacity 65 ml, is sufficient for ap-
prox. 30 min. of operating time.
Filling up chain lubrication oil
1 Avoid spilling the oil.
Wipe off any oil that may have got spilt.
1. Unscrew the oil tank cover and remove it.
2. Fill in the chain lubricating oil carefully until it
reaches the upper marking on the oil level in-
dicator.
3. Tighten the oil tank cover by hand.
1 Caution!
Take care to ensure that no dirt or contami-
nation gets into the oil tank.
3 Recommendation:
In order to prevent environmental damage,
we recommend the use of bio chain lubricat-
ing oil based on vegetable oils.
Working with the chain saw
1 The chain saw has been designed for
sawing wood and felling trees
z Fell only those trees whose trunk diame-
ter is smaller than the length of the chain
saw blade.
1 Prior to each use:
z Check the saw chain and sawing bar for
any signs of damage
z Check the chain tension
z Check the chain lubrication
1 During operation:
z Take care to ensure that you have a sta-
ble standing position.
z Work at an incline above the tree.
z Hold the saw chain away from the body.
z Hold the device tightly in both hands.
z Never stand on a ladder or an unstable
surface or ground.
z Do not use the device above shoulder
height.
1 Caution! Risk of injury
z Do not saw wood that is under tension.
z Do not saw any shrubs or bushes.
Switching the motor on
1. Press the unlock button and keep it
pressed.
2. Press the On / Off button at the rear.
3. Press the On / Off button at the front.
4. Release the unlock button .
Switching the motor off
z Release one of the two On / Off buttons
( or ).
Working method
1 Caution! Risk of rebound or recoil
A rebound or recoil may lead to fatal cut in-
juries.
In the event of a rebound or recoil (kick-
back), the saw is turned suddenly and un-
controllably towards the user.
z The integrated kickback protection re-
duces the risk of a rebound or recoil.
Nonetheless, the risk of a rebound or re-
coil cannot be ruled out entirely.
z Exert uniform pressure on the device,
but not excessive force.
z Place the device, if possible, with the
spiked bumper on the branch to be
sawed off .
Cutting a tree
1. Cut the branch 10-15 cm from the start of the
branch from below upwards up to 1/3 of the
branch diameter .
2. Saw off the branch somewhat more from the
top to the bottom .
3. Make a cut close to the trunk .
J
K
K
K
L
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Li-Ion Power CSA 700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Li-Ion Power CSA 700 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Turkish, Norwegian, Finnish as an attachment in your email.

The manual is 3,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info