638206
19
Zoom out
Zoom in
Previous page
1/202
Next page
19
G
Assembly
General
1 Caution! Sharp saw chain
Tool is still running!
z Always remove battery before perfor-
ming any work on the trimmer!
z Wear safety gloves when doing any work
on the saw chain!
Fastening the saw chain
1. Loosen the screw and remove the chain
cover .
2. Place the saw chain around the sawing
bar .
1 Take care to ensure that the chain is
moving in the right direction .
3. Place the sawing bar along with the saw chain
on the device .
1 Take care to ensure that the chain ten-
sioning pin engages in the sawing
bar.
1 Ensure that the saw chain fits around the
sprocket .
4. Place the chain cover and tighten it on the de-
vice .
Fastening the saw chain
1 The saw chain should not hang loose,
but it should be possible to pull it a few
millimetres away from the sawing
bar .
1. Turn the screw and loosen it enough so
that the sawing bar can be moved by hand.
2. Tighten the chain tensioning screw using a
screwdriver .
3. Turn the saw chain by hand in order to check
that it runs smoothly and properly.
4. Turn the screw so that it is fastened
tightly.
Operation
Times of operation
z Please consult regional/local regulations.
z Inquire about the operating times at your local
regulatory agency.
Charging
1 Attention! Only use battery charger in
dry places.
Before first use, the battery needs to be charged
for about 2 hours.
Use only the original WOLF-Garten charger
(part no. 41A30--E650)!
1. Remove the battery from the device .
2. Insert the battery into the charger .
3. Connect the charger to the mains voltage
(LED lights up green).
3 Notes on charger :
z LED lights up red: Battery is charging
z LED lights up green: Charging com-
pleted
z LED blinks red: Fault (e.g., battery is
too hot)
1 Self-discharge of batteries! Remove the
battery from the charger once it is fully
charged.
3 General instructions:
regarding the battery In order to maintain
the long service life of the battery, always
follow the instructions below:
z The lawn trimmer are automatically swit-
ched off when the battery voltage is low.
The battery must then be recharged be-
fore the shears can be used again.
z
Always recharge the lithium-ion battery
prior to any prolonged period of non-use,
i.e. before storing the shears away in au-
tumn.
z
The charging time is
2
hours for a battery that
is completely empty
.
z
The lithium-ion rechargeable battery can
be charged at any charge level and char-
ging can be interrupted at any time without
damaging the battery (no memory effect)
A
B
C
C
D
C
E
C
H
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Li-Ion Power CSA 700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Li-Ion Power CSA 700 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Turkish, Norwegian, Finnish as an attachment in your email.

The manual is 3,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info