638382
12
Zoom out
Zoom in
Previous page
1/30
Next page
12
G
Starting the engine
z Keep the appliance on an even surface with little or the shor-
test possible grass.
1. Tilt the unit backwards slightly until the front wheels are off the
ground .
2. Depress button and hold (1.).
3. Lift up bar (2.) and release button.
4. Slowly lower the front of the unit until the front wheels are tou-
ching the ground again.
3 Note:
When the cutter deck is in contact with the ground, the unit
can move.
Stopping the engine
z Release switch lever (Fig. 8a).
Scarification
z Start the engine as indicated.
z Push the scarifier along parallel strips of the lawn.
z Place the power cord in large loops on the ground.
Emptying the grass sack
z Release switch lever and wait until the motor stops.
z Lift the deflector flap and unhook the grass sack.
z Empty out the contents.
Transporting
1 Attention! Rotary cutter blade
z pull out the power plug.
z Do not touch running blades.
z Tilt the unit backwards slightly until the front wheels are off the
ground to prevent the blade shaft from touching the ground
.
Maintenance
General
1 Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z pull out the power plug.
z Do not touch running blades.
z Leave the motor to cool down (approx. 30 minutes) be-
fore cleaning, servicing, storing or shutting down the unit.
Cleaning
z Clean the unit thoroughly with a brush after each use.
z Do not spray with water.
z Store unit in a dry room.
3 We recommend
Allow a WOLF-Garten service centre to check the unit in the au-
tumn.
Faults and how to remedy
D
E
D
E
E
G
H
D
Remedy (X) by:
Problem Possible cause
WOLF-Garten
service-workshop
Yourself
No scarification result The working depth is set too low
--- X
Machine runs unevenly, with
heavy vibrations
Blade is damaged due to contact with hard objects
X ---
Abnormal noises or rattling in
the machine
Screws are loose
--- X
Motor will not run
Fuse blown
--- X
Cable damaged:
1 Attention! Electric shock through cable damage
When the cable is cut through or damaged, the
safety fuse doesn’t always trip.
z Do not touch cable, before pulling out the power
plug from the socket.
z Damaged cable has to be completely replaced.
Patching cable with insulating tape is forbidden.
X ---
When in doubt, always consult a WOLF-Garten service workshop.
Important: switch off the scarifi er and disconnect the mains plug before inspecting, cleaning or working on the blades.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Campus 30 V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Campus 30 V in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info