690821

Wmf Lumero - 12360011 Manual

16
Zoom out
Zoom in
Previous page
1/83
Next page
30 31
EN
Descaling
The descaling programme helps maintain the machine, and must be started when the 1-cup button
flashes alternately in blue and white at the latest. Depending on the level of limescale, it can take
up to 90 minutes.
We recommend using a descaler suitable for espresso machines. Follow the manufacturer’s safety
instructions, especially those with regard to what to do in the event of contact with the eyes and skin.
Proceed as follows to start the descaling programme:
1. Prepare the descaler in accordance with the manufacturer’s instructions, add to the water tank and
fill with approx. 750 ml drinking water. Place the tank in the device.
2. Place a receptacle with a capacity of at least 1 litre underneath the spouts.
3. Insert the portafilter holder without the portafilter.
4. Switch on the device.
5. Wait until the device is in standby mode.
6. Press and hold the 1 and 2-cup buttons ->
until the 1-cup button lights up in blue.
Release both buttons – this starts the descaling programme.
7. The descaling programme exits automatically, the machine switches back to standby mode and the
descaler alarm is reset.
Note:
Even if there is no descaling solution left in the tank, the machine still runs a few more pump cycles.
Do not add more liquid to the tank or cancel the descaling programme by operating the mains switch.
If the descaling programme is terminated prematurely, the descaler alarm is not reset!
If this happens, restart the descaling programme (step 6) without adding more liquid.
Allow 3–4 cups of water to run through before making another espresso in order to remove any
remaining descaler from the system.
Malfunctions
Problem Cause Corrective action
No espresso comes out of the
machine.
Tank empty. Fill the water tank.
The spouts on the
portafilter holder are blocked.
There is limescale in the water
circuit.
Clean the holes of the portafil-
ter holder.
The portafilter is blocked
or there is too much coffee
powder in the portafilter.
Clean the holes,
see “Cleaning the coffee
portafilters”.
The water tank has not been
properly
inserted and the valve on the
base of the tank is not open.
Check that the water tank is
properly inserted. Press down
lightly if necessary.
There is limescale in the water
circuit.
Descale as described in the
“Descaling” section
The light ring on the knob is
red.
The device needs to heat up,
but the knob is not switched to
position 0.
Turn the knob to position 0.
Device is preheated and should
generate steam, but the
temperature has not yet been
reached.
Wait until the light ring goes
white and move the knob to
the steam generation position.
Hot water output for 60
seconds.
Turn the knob to position 0.
Steam output for 60 seconds. Turn the knob to preheat steam
position.
The espresso drips over the
edges of the portafilter holder
instead of out of the spouts.
The portafilter holder is not
properly inserted.
Clean the portafilter holder and
insert it properly.
The portafilter holder seal has
lost elasticity or is dirty.
Have the portafilter holder seal
replaced at a customer service
centre or clean it as described
in the “Cleaning the portafilter
holder” section.
The spouts on the portafilter
holder are blocked.
Clean the holes,
see “Cleaning the coffee
portafilters”.
… 16 …


Need help? Post your question in this forum.

Forumrules
1

Forum

wmf-lumero---12360011

Reset search

  • Why is the 1cup button of lumero WMF blinking color blue? What is the problem? Submitted on 30-1-2022 at 18:15

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wmf Lumero - 12360011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wmf Lumero - 12360011 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 37,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wmf Lumero - 12360011

Wmf Lumero - 12360011 User Manual - English, German - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info