603169
5
Zoom out
Zoom in
Previous page
1/16
Next page
Run a solid bead of sealant around the transition plate, making sure to cover each screw head. Be
careful not to get any sealant above the lip of the transition plate. See diagram of transition plate.
Cable Entry Plate Installation:
Decide the best location for the cables to enter the vehicle.
You will need to run:
A coax directly to each receiver location.
A control cable to the TRAV’LER Interface box.
Drill a 1/2” hole in the roof and push the required wires through. (Installations for multiple receivers may
require a larger hole or multiple holes as each receiver requires a dedicated coax cable.) Each receiver
will require at least one coax cable. See receiver manual for wiring details.
Place the cable entry plate supplied in hardware bag over the hole and cables. Screw the plate in place
and seal the plate and screw holes with approved sealant (not included).
Depending on the length of the cable on the roof, you may need to use cable clamps between the unit
and your cable entry plate. Clamping every 12-16” should eliminate any unnecessary cable movement.
FIGURE 4
LIP OF
TRANSITION
PLATE
DO NOT SEAL
SEAL
2
FIGURE 5
OVERALL INSTALLATION DRAWING
!
WARNING: DO NOT cut any
wires when you drill the hole
for your cables.
5
TV
FRONT OF RV
TV 1 TV 3
IDU
A
POWER
B
C
POWER
SUPPLY
For best results, use TV
1 for the receiver that will
be most active.
ENTRY PLATE
Winegard recommends in-
stalling the Accessory Detect
Cable, this can provide a
emergency stow function.
INSTALLATION
RECEIVER
RECEIVER
RECEIVER
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Winegard SK-1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Winegard SK-1000 in the language / languages: English as an attachment in your email.

The manual is 2,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info