335210
6
Zoom out
Zoom in
Previous page
1/8
Next page
41
INSTALLATION
Technical information for the Installer
This cooktop can be embedded in a worktop 20 to 50 mm
thick. If there is no oven beneath the cooktop (any oven
installed must be manufactured by us and equipped with a
cooling system), insert a separator panel at a minimum
distance of 20 mm from the bottom of the cooktop.
Note: before installation, make sure that the local gas
delivery conditions (nature and pressure of gas) are
compatible with the settings of the cooktop, as indicated on
the Product Description Sheet and on the rating plate.
If a vertical piece of furniture is installed, there must be
a gap of at least 100 mm between it and the edge of the
cooktop.
Before installation, remove the plastic film protecting the
appliance, if provided.
The outer surfaces of the furniture or appliances adjacent to
the cooktop must be heat resistant (heat protectionY”)
according to standards.
Installation must comply with current local regulations.
In the room where the cooktop is installed, there must be
enough air to allow the gas to burn correctly
(see the separate Product Description Sheet).
The natural flow of air must take place through an adequate
opening, that must be:
- permanent, made on one of the outside walls of the room,
and communicating with the exterior in an area away from
sources of pollution;
- built so as to ensure that its openings, both on the inside
and on the outside, cannot be obstructed, intentionally or
accidentally;
- protected by a metal grid or mesh that does not reduce its
working section;
- situated near the floor level and positioned so as not to
interfere with the operation of the fume exhaust devices.
- The fume exhaust has to take place through an appropriate
hood or fan installed on the wall or on the window.
Assembly
Apply the supplied gasket to the cooktop (if not yet
fitted), after having cleaned its surface as shown in the
relevant figure.
To secure the cooktop, use brackets (A) supplied with it.
1. Fit the brackets into the relevant bores and fasten them by
means of their screws.
2. Make an opening in the worktop, respecting the dimensions
indicated in the enclosed Product Description Sheet.
3. Install the cooktop in the worktop.
Important: the power supply cable and plug must be
suitable for the power absorption of the cooktop, and the
cable must be long enough to permit its upward extraction.
3gb53241b.fm5 Page 41 Friday, April 11, 2003 12:26 PM
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool akm 200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool akm 200 in the language / languages: English as an attachment in your email.

The manual is 0,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool akm 200

Whirlpool akm 200 Additional guide - English - 2 pages

Whirlpool akm 200 Additional guide - Dutch - 2 pages

Whirlpool akm 200 User Manual - Dutch - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info