813316

Westfire WF32 Manual

11
Zoom out
Zoom in
Previous page
1/36
Next page
WESTFIRE · WF32 WESTFIRE · WF32
11
UK
INSTALLING THE APPLIANCE
I) Remove door and frame
a. Open door to 90 degrees
b. Remove safety plate with allen key on top hinge
c. Lift door so bottom hinge pin is out of the holding hinge plate
d. Tilt base away from stove and lower door
e. Door should now be released
f. Place door in a safe place
II) Remove frame from stove
a. Once door is removed
b. Loosen four Allen keys and frame will come away
III) Remove Brick set
a. See manual below
IV) Remove Bar from flue collar
a. Loosen bolts holding flue collar
b. Remove flue collar taking care not to lose nuts and bolts.
V) Fit collar to stainless steel flue( we recommend a 500 mm
of 1mm stainless steel if possible)
VI) Fill any Void with at the back and sides with a 6;1 vermiculite
to cement mix or any other good quality non-combustible
insulation material. It is important that the back and sides of
the stove are well insulated.
VII) Connect the stove to the flue
a. Pull stove collar to top of stove from inside the appliance
b. Align bolt locations and re-bolt the spigot (and Flue) to stove
c. Tighten bolts and secure
VIII) Finish around stove
IX) Re-fit frame
a. If a newly plastered room please take care not to leave painted
frame and door fitted as the extremes of moisture while the
plaster dries and can cause corrosion to the paint work
b. Before re-fitting door and frame, store door and frame in a dry
and well ventilated place while allowing the plaster to dry
X) Re-fit door
XI) Re-fit brick as shown in the instructions in this booklet
To remove frame, after removing door,
unscrew 4 allen keys securing ther frame.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Westfire WF32 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Westfire WF32 in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 2.22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info