798854
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
Troubleshooting
GREASY BARBECUE (Peeling Paint & Flare-Ups)
SYMPTOM
• Inside of lid appears to have the appearance of peelingpaint.
CAUSE SOLUTION
The flakes you see are accumulated cooking vapours
that have turned into carbon.
This happens over time after repeated use of your
barbecue. This is not a defect. Clean the lid. Refer to
the “Product Care” section.
SYMPTOM
• Experiencing flare-ups when barbecuing or preheating.
CAUSE SOLUTION
There is leftover food from the previous meal. Always preheat the barbecue on the highest setting for
10to 15 minutes.
The inside of the barbecue needs to be cleaned
thoroughly.
Follow the steps in the "Cleaning and Maintenance"
section to clean the barbecue inside from the top
down.
m WARNING: Do not attempt to make any repair to gas carrying, gas burning, ignition components or
structural components without contacting Weber-Stephen Products LLC, Customer Service Department.
m WARNING: Failure to use genuine Weber-Stephen parts for any repair or replacement will void all
warranty protection.
m CAUTION: The burner tube openings must be positioned properly over the valve orifices.
Proper Burner Flame Pattern
The burners in your barbecue were factory set
for the correct air and gas mixture. When the
burners are performing correctly, you will see a
specific flame pattern. The tips may occasionally
flicker yellow (A), with a descending light blue (B)
to dark blue flame (C).
m WARNING: Blocked and dirty ports can
restrict full gas flow, resulting in a fire (D) in
and around the gas valves, causing serious
damage to your barbecue.
Spider Screens
The combustion air openings of the burners(E)
are fitted with stainless steel screens to prevent
spiders and other insects from spinning webs
and building nests inside the burners. Dust and
debris can accumulate on the outside of the
spider/insect screen and obstruct the oxygen
flow to the burners.
CALL
CUSTOMER
SERVICE
If you are still experiencing any
problems, contact the CustomerService
Representative in your area using
the contact information on
weber.com.
E
B
A
C
D
GAS FLOW
SYMPTOM
• Barbecue does not reach desired temperature or heatsunevenly.
• One or more of the burners fail to ignite.
• Flame is low when burner is on high position.
• Flames do not run the whole length of the burner.
• Burner flame pattern is erratic.
CAUSE SOLUTION
Some countries have regulators with a “flow limiting
device” that has been activated. Thissafety feature
built into the regulator restricts the gas flow in the
event of a gas leak. You can inadvertently activate this
safety feature without having a gas leak. This typically
occurs when you turn on the gas at the LPG cylinder
and one or more of the control knobs are not in the
o position. It may also occur if you turn on the LPG
cylinder too quickly.
Reset the “flow limiting device” by closing the LPG
cylinder valve and turning all the burner control
knobs to the o position. Wait five minutes to
allow accumulated gas to dissipate, then ignite the
barbecue again following the instructions in the
“Operation” section.
The LPG cylinder is low or empty. Refill LPG cylinder.
Fuel hose is bent or kinked. Straighten fuel hose.
Burner ports are dirty.
Clean burner ports. Refer to “Cleaning the BurnerPorts.”
SYMPTOM
• Gas is smelled in conjunction with burner flames that appear yellow andlazy.
CAUSE SOLUTION
Spider screens on the burners are obstructed. Clean spider screens. Refer to “Cleaning the Spider
Screens” in the Product Care section. Also refer to
the illustrations and information in this section about
proper flame pattern and spiderscreens.
SYMPTOM
The smell of gas and/or a light hissing sound.
CAUSE SOLUTION
The internal rubber seal in the LPG cylinder valve
could be damaged.
Inspect the rubber seal for damage. If damaged,
return LPG cylinder to local retailer.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Weber Spirit E220 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Weber Spirit E220 in the language / languages: English as an attachment in your email.

The manual is 13.43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Weber Spirit E220

Weber Spirit E220 Installation Guide - German - 40 pages

Weber Spirit E220 User Manual - German - 24 pages

Weber Spirit E220 Installation Guide - Dutch - 40 pages

Weber Spirit E220 User Manual - Dutch - 24 pages

Weber Spirit E220 Installation Guide - French, Italian - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info