694507

Wanders Pecan Eco Manual

18
Zoom out
Zoom in
Previous page
1/64
Next page
18
GB
• place 2 relighter blocks in the centre of the grate
• create a pyramid of 8 to 10 pieces of tinder about 3 cm thick and 25 cm long around the relighter blocks
• light the relighter blocks and leave the door slightly ajar
• once the re is burning well and there is no more condensation on the window, close the door
• when the wood-burning stove is hot, close the ue gas valve by pushing the lever (on the left behind the wood-burning
stove) to the right
• do not add any more wood to the wood-burning stove, simply allow the wood-burning stove to go out and cool to room
temperature
• repeat this procedure 3 times
• then repeat the procedure one more time, but this time add 1 kg of wood and allow the wood-burning stove to go out
again
• repeat this procedure 3 times
When you light the Pecan Eco for the rst time, the hearth must still ‘anneal’ and temper itself. The unit has a heat resistant
lacquer which must burn in the stove at temperatures above 400 °Celsius. This will happen during the rst few times of
lighting the stove and temperatures rise to 600 °C. Though this may give an unpleasant smell, it is otherwise harmless. It is
advisable to keep the stove burning with limited fuel for at least 6 hours when lighting the stove for the rst 4 or 5 times. Air
the room well when the stove is burning. Make sure that any cooking hood is not turned on when the stove is burning; a
cooking hood extracts the combustion air that the stove needs.
Some deposit may form on the glass panes of the stove when you ‘anneal’ your hearth. You can easily remove this deposit
with a damp cloth after the stove has cooled down. You can also use some cleansing agent for ceramic rings. Please make sure
you do not leave any nger marks on the clean glass. Finger marks burn into the glass and cannot be removed later.
Newly built house or recently renovated?
It is advisable to wait six weeks before lighting the stove in a newly built house that has recently been
completed, or in a space that has recently been renovated drastically. The walls and ceilings still contain
gases, softeners and moisture from plasterwork or paint. The warm air-streams may discolour the dust
particles in the space, which may stick to walls and ceilings. Even the moisture in the walls and ceilings will
become warm and may cause yellow stains.
HI2 Insides
The HI2 insides were specially developed for WFS and, without giving away too much of our secret
recipe, comprise a mix of special concrete with vermiculite. The heat-reective action of the vermiculite
generates heat build-up in the combustion chamber while the rest of the material stores the heat.
Once combustion is well under way, you will see a perfect re – clean, eco-friendly combustion with a
high heat yield.
The re bricks, weighing in at some 30 kg, initially require thorough heating. The heat in the combustion chamber is key to
ensuring the stove works properly. We therefore advise getting the re going with thinner, more easily combustible wood.
Leave the doors slightly ajar for a quarter of an hour so the re quickly starts to burn ercely.
If you then ensure a red-hot bed of ash for further combustion, this will create decent ames and radiant heat that you can
enjoy for the rest of the evening, while occasionally adding fresh wood.
The heat is stored by the re bricks - known as accumulation - so any fresh logs ignite quickly. This accumulating action means
that the stove continues to give o heat for a long time after the re is extinguished.
The HI2 insides are made using water, so the moisture will have to be heated out of the re bricks during the rst few sessions.
Our advice is to get a really good re going for the rst few hours. At that point, the re will probably not look like it did in the
showroom, but the appearance will improve rapidly after the rst couple of res.
… 18 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wanders Pecan Eco at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Pecan Eco in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info