813271

Wamsler K158 Manual

48
Zoom out
Zoom in
Previous page
1/120
Next page
48
4. INSTRUCTIONS
4.1 General information
The following directions and instructions concern questions of fundamental importance. It
is further presupposed that the installer of a heating plant has the necessary technical and
craftsman's basic knowledge for the task. This is naturally also the assumption where the
stove is being incorporated as an integrated stove into an existing system.
Heating stoves with heat exchangers are only suitable for closed systems with a heat sink.
Stoves without heat exchangers should be used with a heat sink.
The regulations according to EN 12828, EN 12831 and EN 12897 apply.
We do however recommend using the external heat sink in conjunction with a domestic
water boiler even for open systems, to control the stove's boiling function when there is a is
a limited heating requirement of hot water.
4.2 Important Notes
The heating stove must be put in place using a spirit level to ensure correct adjustment.
Threaded pipe connectors, straight or angled, should be used to for the flow and return
connections. Sleeves fittings or welding should not be used.
Horizontal pipe exits from the heating stove are to be in 1"-diameter. Reductions can only
be made in vertical connections.
The filling and emptying cock should always be located at the lowest point of the system in
the return connection.
Up to a static height of 10 m, the capacity pressure expansion vessel is dependent on the
water capacity of the system as follows:
Water content Vessel size
Litre Litre
up to 111 12
112 - 167 18
168 - 231 25
232 - 324 35
325 - 463 50
464 - 741 80
There should no manually operable shut off valves installed between the expansion vessel
and the stove.
A ventilation section at least 0.5 m above the highest circulation point in closed systems
with a diameter of at least 1″ should be arranged and a ventilation valve provided at the
upper end.
In gravity systems the rise and fall of horizontal pipes should be at least 0.5 cm/m.
Radiators with more than 25 ribs or plate heat exchangers over 1.5 m long should be di-
agonally connected to the flow and return pipes.
… 48 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wamsler K158 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wamsler K158 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 2.07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info