540479

Vortex Viper PST Manual

7
Zoom out
Zoom in
Previous page
1/11
Next page
12 13
Bore Sighting
Initial bore sighting of the riflescope will save time and
money at the range. This can be done by using a mechanical
or laser bore sighter according to the manufacturer’s
instructions or by removing the bolt and sighting through
the barrel on some rifles.
1. Place the rifle solidly on a rest and remove the bolt.
2. Sight through the bore at a target approximately 100 yards
away.
3. Move the rifle and rest until the target is visually centered
inside the barrel.
4. With the target centered in the bore, make windage and
elevation adjustments until the reticle crosshair is also centered
over the target.
To visually bore sight a rifle:
Visually bore-sighting a rifl e.
After installing the bottom ring halves on the mounting base,
place the riflescope on the bottom ring halves and loosely install
the upper ring halves. Before tightening the scope ring screws,
adjust for maximum eye relief to avoid injury from recoil:
Eye Relief and Reticle Alignment
1. Set the riflescope to the middle of its magnification range.
2. Slide the riflescope as far forward as possible in the rings.
3. While viewing through the riflescope in a normal
shooting position, slowly slide the riflescope back towards
the shooter’s face—paying attention to the field of view. Just
as the full view is visible, stop.
4. Without disturbing the front-back placement, rotate
the riflescope until the vertical crosshair exactly matches
the vertical axis of the rifle. Use of a reticle leveling tool, a
weight hung on a rope, or an adjustable set of feeler gauges
will help with this procedure.
5. After aligning the reticle, tighten and torque the ring
screws down per the manufacturer’s instructions.
Use of an adjustable set of feeler
gauges between a one-piece
base and fl at bottom section
of the rifl escope to square the
rifl escope (and reticle) to the
base.
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vortex Viper PST at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vortex Viper PST in the language / languages: English as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info