540479
6
Zoom out
Zoom in
Previous page
1/11
Next page
Use 30mm rings with the Viper PST.
10 11
Riflescope Mounting
To get the best performance from your Vortex Viper PST
riflescope, proper
mounting is essential.
Although not difficult,
the correct steps must
be followed. If you are
unsure of your abilities,
it would be best to
use the services of a
qualified gunsmith.
Centering of the Reticle
The Vortex Viper PST riflescope is pre-set from the factory
with the reticle in the center of the adjustment ranges.
1. Turn the windage or elevation dial as far as possible in either
direction. Do not force the dial. As soon as any any resistance is felt,
stop turning.
2. Carefully count the dial rotations while turning the dial back
in the opposite direction. Stop turning as soon as resistance is felt.
3. Turn the dial the other direction to half the amount of
rotations counted in step one.
If you have changed the settings and wish to approximately
reset the reticle to the center, this can be done easily:
Complete this procedure for both windage and elevation
dials to approximately center the reticle
.
Rings and Bases
Mount an appropriate base and matching rings to your rifle
according to the manufacturer’s instructions. The Vortex
Viper PST riflescopes require 30mm rings.
Vortex Optics highly recommends using the Vortex Optics
Precision Matched 30mm ring sets which may be purchased
from an authorized Vortex riflescope dealer. These rings will
mount to any Picatinny spec base.
Note: If the rearm is not already equipped with a Picatinny base, these
are readily available for most ri es at larger rearms retailers.
If using an aftermarket base and ring setup, use the lowest
ring height that will provide complete clearance of scope and
rifleavoiding any contact with barrel, receiver, bolt handle
or any other part of the rifle. A low mounting will help assure
proper cheek weld, aid in establishing a solid shooting position,
and promote fast target acquisition.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vortex Viper PST at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vortex Viper PST in the language / languages: English as an attachment in your email.

The manual is 0,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info