540497

Vortex VIPER HS LR Riflescope Manual

8
Zoom out
Zoom in
Previous page
1/11
Next page
HS LR
RIFLESCO PE
1. Loosen the three turret cap retaining screws on the elevation turret.
Gently pull the turret cap straight up and off of the turret post—being
careful not to rotate the turret post.
2. Slide the CRS shims on the center section of the turret post below
the V-grooved part.
3. After filling the center gap on the post with shims, replace the
elevation cap.
After obtaining a satisfactory zero, the CRS stop can be set using the
following technique:
Setting the CRS Stop and Indexing Elevation Knob
4. Align the turret cap so the “0” mark on the cap matches up with the
“0” reference line on the turret post. Again, be sure not to rotate the
actual turret mechanism in the process.
5. Re-tighten the retaining screws, but do not overtighten. Use of
thumb and forefinger on the short end of the hex wrench will provide
sufficient force.
Use as many shims as necessary
to completely fill up the space.
Do not try to force in a last shim
once the clearance is very close.
Indexing Windage Dial with Zero Reset
Viper HS LR riflescopes feature a windage dial that will allow you to
re-index the zero indicator after sight-in without disturbing your settings.
This allows you to quickly return to your original zero if temporary windage
corrections are used in the field. Index the windage dial in this way:
1. Remove the outer cap and pull the adjustment dial outward against
the spring tension until it stops.
2. With the dial pulled fully outwards,
rotate the dial to reposition the zero mark
on the index line.
3. Release the dial,
allowing it to return to the
normal inward position.
Grasp turret dial and pull outward. Then,
rotate dial until the etched zero mark aligns
with the indicator line on scope body.
Remove the outer
cap and expose the
turret dial.
Alternate shim installation
direction 180 degrees with
each shim.
Place CRS shims in this groove.
15 14
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vortex VIPER HS LR Riflescope at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vortex VIPER HS LR Riflescope in the language / languages: English as an attachment in your email.

The manual is 0,46 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info