02 Locks and alarm
Remote key and key blade
02
61
3. Insert the key blade as far as possible in
the driver's door lock. Turn the key blade
to unlock the driver's door. This will trig-
ger the alarm.
4. To turn off the alarm, insert the remote
key in the ignition slot. This also applies
to vehicles equipped with the optional
keyless drive.
5. Press the cover back into place after the
door has been unlocked.
Replacing batteries in the remote
key/PCC
The battery/batteries in the remote key/PCC
should be replaced if:
•
The information symbol lights up and a
text appears in the information display.
and/or
•
the vehicle's locks repeatedly do not
react when a button on the remote
key/PCC is pressed within approximately
60 ft (20 m) from the vehicle.
Battery type CR 2430, 3 V (one battery in the
remote key, two batteries in the PCC)
Opening the remote key/PCC
Slide the spring loaded catch to the
side.
Pull the key blade straight out of the
remote key.
Insert a small screwdriver in the hole
behind the spring loaded catch and care-
fully pry up the cover.
NOTE
Turn the remote key with the buttons
upward so that the batteries do not fall out
when the cover is removed.
Replacing the batteries
CAUTION
When handling batteries, avoid touching
their contact surfaces as this could result
in poor battery function in the remote key.
Note the position of the battery's (+) or (–)
sides.
Remote key (one battery)
1. Use a screwdriver to pry out the old bat-
tery.
2. Insert a new one with the (+) side down-
ward.
