738218

Voltcraft VC165 Manual

41
Zoom out
Zoom in
Previous page
1/96
Next page
41
c) Inserting and changing the batteries
Operation of the meter requires a 9 V block battery (e.g. 6F22 or same build). You need to insert a new, charged
battery before initial operation or when the battery change symbol appears on the display.
Proceed as follows to insert or change the batteries:
- Disconnect the connected measuring lines from the
measuring circuit and the meter. Switch off the DMM.
- Loosen the rear screws at the battery compartment (10)
with a matching Phillips screwdriver. Remove the battery
compartment from the device.
- Replace the at battery with a new one of the same type.
Place a new battery in the battery compartment, observ-
ing the correct polarity. The battery only ts the holder
in the correct polarity. Do not use any force for insertion.
Observe the polarity as indicated in the battery compart-
ment.
- Re-insert the battery compartment in the device.
- Close and screw shut the casing carefully again.
Never operate the meter when it is open. !DANGER TO LIFE!
Do not leave at batteries in the meter. Even batteries protected against leaking can corrode and
thus release chemicals which may be detrimental to your health or destroy the device.
Do not leave batteries lying around carelessly. They could be swallowed by children or pets. If
swallowed, consult a doctor immediately.
Remove the battery if the device is not used for extended periods of time to prevent leaking.
Leaking or damaged batteries may cause alkali burns if they come in contact with the skin. There-
fore, use suitable protective gloves.
Make sure that the batteries are not short-circuited. Do not throw batteries into the re.
Batteries must not be recharged or dismantled. There is a risk of re and explosion.
You can order suitable alkaline batteries stating the following item no.:
item no. 652509 (please order one).
Only use alkaline batteries, as they are powerful and have a long service life.
… 41 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Voltcraft VC165 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Voltcraft VC165 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info