626251
10
Zoom out
Zoom in
Previous page
1/13
Next page
10
Before replacing the electrodes, make sure that you have correctly turned off the collar
(remove the battery from it).
If you have a longwooled dog, use long electrodes (they are typically delivered as the
accessories to the delivery) and vice versa (for short electrodes, refer to Optional accesso-
ries). Electrodes should be slightly tightened by hand. Do not use pliers or any other tools
to tighten the electrodes as you can cause an irreparable damage to the product.
Replacement of electrodes
Checking the correct functionality
You can check any time whether your d–fence operates correctly and visualize its opera-
tion using the testing discharge lamp.
Before you are going to carry out this check, make sure that the receiving collar is
turned off (the battery is removed from it).
Connect the testing discharge lamp to the electrodes and ensure a reliable contact (you can
pull in the lamp wires under the electrodes or to make a loop round the electrodes).
Install a battery in the collar. Connect the transmitter to the power adapter (plug the power
adapter in the mains socket outlet) and turn on the transmitter by setting the switch to ”ON“.
Walk slowly towards the antenna wire. At fi rst you should hear a warning beep and after
approaching closer to the wire, the testing discharge lamp should be lit.
In this case your unit works perfectly.
Before the testing discharge lamp is disconnected, remove the battery from the collar!
Checking the preset mode
If you need it or when the behavior of your dog is changing as it is getting used to the
d–fence, you can check the mode you set some time ago.
Checking your DOGtrace™ d–fence
1. Antenna wire cut-off
If the antenna wire is cut off (or there is a failure in connection), the transmitter will warn
you about the functional failure by intermittent beeping and the Loop error LED fl ashes
on and off .
2. Warning zone leaving
After some 20 seconds of permanent presence in the warning zone, your dog will be
warned to leave it by a few short correcting pulses.
3. Correcting zone leaving
If your dog stays motionless in the correcting zone for about 20 seconds, the system will
stop emitting the correcting pulses. The correcting cycle will be restored, after your dog
leaves this zone.
Three functions of the safety system
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VNT DOGtrace d-fence at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VNT DOGtrace d-fence in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info