626251
9
Zoom out
Zoom in
Previous page
1/13
Next page
9
Correction pulse intensity setting
There are 8 modes for setting a correction
pulse level and 1 mode for testing intensity
of interference signals. You can adjust
correction level according to size and
sensitivity of your dog.
Changing a mode
Turn the receiver on (battery inserted).
Place the magnet, to a target marked
on the receiver – see picture X.
A certain number of beeps are emitted
indicating a mode (1–9).
After the required mode is set, remove
the magnet from the receiver. The receiver
saves the mode confi guration into its memory.
The table below shows how d–fence works in diff erent modes and recommends the right
mode according to dog breeds sizes.
Interference Signal Intensity Test (ISIT)
The unique and patented ISIT function enables the
detection of interference signal intensity where the wire is
being laid. This helps avoid potential functionality problems
of the d–fence system. In the ISIT mode (mode no. 9),
the receiver detects intensity of interference signals.
A red LED diode starts blinking when an interference signal
is detected. The blinking frequency increases with increasing
intensity of interference signals. If the LED diode shines
permanently, the interference signal intensity is very high.
It is not recommended to lay a wire in an area where
an interference signal is detected. It could signifi cantly
infl uence correct functionality of the d–fence.
Note: The device is set to mode 4 by default.
No. of beeps
1
2
3
4
5
6
7
8
9
Dog breed size
small
small
small
medium
medium
large
large
large
Level of correction
very low
low
medium
higher
high
very high
extremely high
maximum
Mode
1
2
3
4
5
6
7
8
9
Interference signal intensity test (ISIT)
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for VNT DOGtrace d-fence at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of VNT DOGtrace d-fence in the language / languages: English as an attachment in your email.

The manual is 0,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info