744772
11
Zoom out
Zoom in
Previous page
1/20
Next page
11
G
3.2 Turning on and off
1. STARTING UP
To turn your VR 302 on, switch the ON/OFF button on the right side of the device. You will hear a welcome melo-
dy and the LED display will be illuminated. To start the standard or intensive cleaning cycle press the “POWER” or
“MAX” button on either the LED display or the remote control.
To pause the robot press the “POWER” button again.
NOTE: when starting the robot, always place it in the middle of a room or surface, at least half a meter away from
any clis.
2. STANDBY
Standby means, the robot’s main power is turned on, and the robot is ready to use. Through one of the following
methods, you can change into standby mode:
When robot is cleaning, press “POWER” button on main body to pause robot and enter standby mode.
When cleaning, press the ON/OFF on remote controller to pause the robot to enter standby.
3. SLEEP MODE
In sleep mode, the robot’s display will turn dark (but robot is not powered off).
In order to save power, you can turn the robot into sleep mode from standby mode via either of the following methods:
a. Long press “POWER” button on main body for 3 seconds, robot will enter into sleep mode.
b. Robot will automatically enter sleeping if power is low when in standby mode.
4. POWER OFF
To turn the device off, switch the ON/OFF button on the right side of the robot.
3.3 Cleaning modes & movement patterns
THE ROBOT IS EQUIPPED WITH FOUR DIFFERENT CLEANING MODES
1. Eco Cleaning Mode The robot cleans the room automatically and adjust its
cleaning pattern according to the room’s architecture. The Eco
mode balances energy consumption and the cleaning
performance.
2. MAX Cleaning Mode The robot will increase it’s suction power and slow down in
speed to reach the peak performance and clean dirtier areas
thoroughly.
NOTE: On carpet it is recommended to always use MAX mode
to achieve best results.
3. Spot Cleaning Mode In this mode, the robot will clean intensively in a spiral way with
more suction power. This mode is created for picking up dirt
on a limited area of around 1,20 m x 1,20m. The mode lasts 90
seconds.
When activated in standby the robot will start and stop at the
same position. When activated while the robot is already
cleaning the robot will continue cleaning after the Spot
cleaning mode has finished.
4. Scheduling mode After scheduled, the robot will leave the dockingstation and
start working daily in the Eco mode at the scheduled time.
11


Need help? Post your question in this forum.

Forumrules
1

Forum

vileda-vr-302

Reset search

  • vileda vr302 robot vacumn stopping after a minute showing error code 77 Submitted on 27-3-2023 at 15:36

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vileda VR-302 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vileda VR-302 in the language / languages: English as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info