667332

Viking MT 5097 Manual

31
Zoom out
Zoom in
Previous page
1/290
Next page
ENES
29
PTEL
0478 192 9807 C - EN
10.1 5-digit segmental display
The 5-digit segmental display provides
information about operating hours and
battery voltage. It also indicates faults by
displaying the text ERROR.
The operating hours and battery voltage
can be called up during operation by
pressing the Mode button. (Ö 10.3)
Operating hours:
Display of the engine operating hours in
full hours (e.g. 281 h).
The hour meter cannot be reset.
The correct times for maintenance or
service operations are determined based
on the meter. These are indicated in the
maintenance schedule. (Ö 15.1)
Battery voltage:
Display of the current battery voltage in
volts (e.g. 12.0 V).
10.2 Set button
Pressing the Set button during
display of the operating hours or
battery voltage switches to
continuous display.
Turning the ignition key to the "engine off"
position resets the display to the default
setting (display of operating hours or
battery voltage for 5 seconds).
10.3 Mode button
Pressing the Mode button switches
between the individual displays:
1 Operating hours [h]
2 Battery voltage [V]
3 No display
The operating hours and battery voltage
are both displayed for 5 seconds. Press
the Set button for a continuous display.
(Ö 10.2)
10.4 Display of faults
Engine oil pressure too low
symbol:
The oil pressure required for
correct operation of the engine is too low.
The engine will be stopped within 3
seconds.
● Do not attempt to restart the engine.
● Visually check for oil leaking from the
engine.
● Check the oil level and top up the
engine oil if necessary.
Battery fault symbol:
The battery voltage is too low. The
battery is faulty or is not
recharging. The current voltage is
additionally shown in volts on the display
(e.g. 10.5 V).
The engine is stopped or cannot be
started.
● Do not attempt to restart the engine.
● Check the battery voltage on the
display.
● Check the fuses and replace if
necessary. (Ö 15.20)
● Visually check for leaking battery fluid.
● Check battery terminals for corrosion
and correct seating.
● Charge the battery. (Ö 15.21)
● Replace the faulty battery. (Ö 15.19)
10.5 Display of operating information
Reverse mowing symbol:
The symbol is continuously
displayed when reverse mowing is
enabled.
The symbol flashes when the reverse
mowing safety switch is pressed or if an
enable is required for reverse mowing.
(Ö 8.8)
The symbol disappears from the
display:
– When reverse mowing is completed.
Switches from flashing to continuous
display:
– When reverse mowing is enabled.
– When the mowing deck is manually
disengaged within the time window.
12 Discharge chute removed
Active functions (Ö 10.6)
13 Cruise control active
14 Mowing deck active
Operating information (Ö 10.5)
Avoid damage to the machine.
The oil pressure warning is not an
oil level indicator. Therefore check
the oil level at regular intervals.
If symbols do not display as
expected or do not disappear as
described, the probable cause is a
fault in the respective switch, in the
plug connections or in the wiring.
Consult your specialist dealer.
VIKING recommends VIKING
specialist dealers.
… 31 …


Need help? Post your question in this forum.

Forumrules
1

Forum

viking-mt-5097

Reset search

  • how do i replace the transmission cable on the Viking MT 5097.oz Serial number 980075680
    Submitted on 4-10-2024 at 18:46

    Reply Report abuse

  • I need to change the ground drive belt in my MT 5097. Are there any instructions available for this? Submitted on 4-4-2022 at 18:58

    Reply Report abuse

  • I need to replace the drive belt in my MT 5097. Are there any instructions available for this? Submitted on 4-4-2022 at 18:57

    Reply Report abuse

  • Hello,
    We Have a Viking MT 5097Z.
    The engine stopped at once.
    When i turn on the Key to run it, the 10A fuse melts (twice) - not the 15A fuse.
    Is it possible one relay is broken (short-circuit) ? - N° 18,19, 25, 26 on the electric map -
    Or what other possibility?
    Thank's for your answer
    Best regards
    Franck
    Submitted on 4-1-2022 at 12:40

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MT 5097 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MT 5097 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 24,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Viking MT 5097

Viking MT 5097 User Manual - German, Dutch, French, Italian - 284 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info