667332

Viking MT 5097 Manual

29
Zoom out
Zoom in
Previous page
1/290
Next page
ENES
27
PTEL
0478 192 9807 C - EN
Disengaging the gearbox:
Pull the gearbox freewheel lever (1)
outwards to the stop and then raise.
Engaging the gearbox:
Guide the gearbox freewheel lever (1)
downwards and then press inwards to the
stop.
8.19 Level sensor (grass catcher box)
A continuous tone sounds if the grass
catcher box is full. This signals that the
grass catcher box needs to be emptied.
The time for the filled grass catcher box
signal is adjusted by modifying the length
of the (grass catcher box) level sensor.
This allows you to adapt filling of the grass
catcher box to the characteristics of the
clippings.
A shorter sensor generally causes later
triggering of the signal (the grass catcher
box is filled to a greater extent, ideal for
very dry clippings).
The level sensor can be adjusted to 6
notched positions.
In delivery condition, the level sensor
(grass catcher box) is fully extended.
Adjusting the level sensor:
● Stop the engine. (Ö 13.3)
● Engage the parking brake. (Ö 8.14)
● Remove the grass catcher box.
(Ö 13.10)
Extend or shorten the level sensor by
moving the slide (1) of the (grass catcher
box) level sensor in the direction of the
arrows.
● Attach the grass catcher box. (Ö 13.10)
In order to ensure safe operation, the ride-
on mower is equipped with electronics
which check all the safety devices before
each starting procedure and when the
mower is running.
9.1 Self-diagnosis when starting
Before the engine is started, the
electronics perform self-diagnosis. This
checks switches, wiring, etc. for correct
functioning.
Activating self-diagnosis:
● Sit on the driver's seat.
● Release the parking brake. (Ö 8.14)
● Turn the ignition key to the "ignition on"
position (Ö 8.1) – do not press any
buttons and switches or actuate any
pedals.
Self-diagnosis without faults:
A short beep sounds – the electronics are
activated and the ride-on mower is ready
to start.
MT 6112 C, MT 6112 ZL, MT 6127 ZL:
All symbols are shown on the display for
2 seconds. The operating hours can be
read off for 5 seconds.
● Start the engine. (Ö 13.2)
Disengaging the mowing deck
stops the continuous tone.
9. Electronics
The electronics in the models
MT 6112 C, MT 6112 ZL,
MT 6127 ZL also control the
display. The display on these
models therefore shows additional
information.
… 29 …


Need help? Post your question in this forum.

Forumrules
1

Forum

viking-mt-5097

Reset search

  • how do i replace the transmission cable on the Viking MT 5097.oz Serial number 980075680
    Submitted on 4-10-2024 at 18:46

    Reply Report abuse

  • I need to change the ground drive belt in my MT 5097. Are there any instructions available for this? Submitted on 4-4-2022 at 18:58

    Reply Report abuse

  • I need to replace the drive belt in my MT 5097. Are there any instructions available for this? Submitted on 4-4-2022 at 18:57

    Reply Report abuse

  • Hello,
    We Have a Viking MT 5097Z.
    The engine stopped at once.
    When i turn on the Key to run it, the 10A fuse melts (twice) - not the 15A fuse.
    Is it possible one relay is broken (short-circuit) ? - N° 18,19, 25, 26 on the electric map -
    Or what other possibility?
    Thank's for your answer
    Best regards
    Franck
    Submitted on 4-1-2022 at 12:40

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MT 5097 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MT 5097 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 24,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Viking MT 5097

Viking MT 5097 User Manual - German, Dutch, French, Italian - 284 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info